资源列表
RC522
- RC522的读写程序 利用串口进行读写，测试已经通过可用-Rc522 UART
ModBus_rs485_send
- 基于dspic33f单片机，RS485硬件的ModBus通讯协议程序，初始状态为发送-Based on dspic33f microcontroller, RS485 ModBus communication protocol program the hardware, the initial state to send
e-bike-ctrl-sch-mega48
- 电动自行车控制器详细原理图，对无刷电机控制开发有帮助-Electric Bicycle Controller detailed schematic diagram of brushless motor control development help
svpwm_PMSM_090312
- 采用Matlab/simulink实现了基于SVPWM的PMSM仿真，实现了基于参考电压的仿真-Using Matlab/simulink implementation of PMSM based on SVPWM simulation, the reference voltage based on the implementation of the simulation
shumaguanduojicaidan
- 数码管的多级菜单程序基于51单片机的proteus仿真-Digital multi-level menu program proteus simulation based on 51 MCU
W25Q16
- 用c语言写的华邦SPI串行Flash驱动程序。已经用在产品上。-W25Q16 SPI flash memery driver program.
Source-Code
- nrf24lu1开发完整全代码，自带一个usb鼠标和键盘的源程序-nrf24lu1 complete the whole development of the code, comes with a usb mouse and keyboard of the source
code
- 利用微处理器 AVR ATmega 128，温湿度传感器SHT11/71,压力传感器MS5534A, 光传感器TSL2550，加速度传感器ADXL202E-Use of microprocessors AVR ATmega 128, temperature and humidity sensors SHT11/71, pressure sensors MS5534A, light sensors TSL2550, acceleration sensor ADXL202E
W25X32
- 本程序是华邦存储芯片W25X32的驱动程序，用的是STC主芯片驱动，用C语言编程，完全可移植到其他51内核单片机主芯片上，将IO口修改即可，使用的编程软件为KEIL，已在试验板上调试过-This procedure is Winbond W25X32 driver memory chips, the main chip used is the STC-driven, with the C programming language, fully portable to other 51-core
ad7705
- 16位的AD7705的单片机测量程序，在高精度的数据采样中使用方便精确。-The AD7705 16-Bit MCU measurement procedures, the high-precision sampling of easy to use accurate data.
STC12C5A60S2-danzhudancong
- STC单片机SPI例子程序,STC12C5A60S2单片机,单主单从模式-STC microcontroller SPI example program, STC12C5A60S2 single chip, single-master single-slave mode
Manchester
- 使用C语言编写的曼彻斯特编码和解码功能函数-Written in C language with Manchester encoding and decoding functions