资源列表
max765x_adc
- This program shows how to configure and use the A/D Converter of the following microcontrollers: Maxim MAX7651 Maxim MAX7652-This program shows how to configure and use the A / D Converter of the following microcontro llers : Maxim MAX7651 Max
ds400_srom
- This prj demonstrates how to use the SROM memory classes for the Dallas DS80C400. This example uses the memcpy function to copy a function in the SROM memory class (which is located in CODE memory) to von Neumann mapped XDATA (starting at 0x110000) f
rx2_wdt
- This program shows how to configure the watchdog timer for the following chips: Atmel 80C51RA2 Atmel 80C51RD2 Atmel 80C54X2 Atmel 80C58X2 Atmel 83/87C51RB2 Atmel 83/87C51RC2 Atmel 83/87C51RD2 Atmel T87C5111 Atmel T87C5112 Atmel
at89s8252_spi
- AT89S8252, AT89S53 SPI Program, This program shows how to configure and use the SPI in master mode for the following microcontrollers: ATMEL AT89S53 ATMEL AT89S8252-AT89S8252, AT89S53 SPI Program, This program shows how to configure and use
can_505c
- RTX51 CAN Program for the Infineon C505C, This program demonstrates how to transmit and receive CAN messages using the Infineon C505C Micrcontroller s integrated CAN Controller. -RTX51 CAN Program for the Infineon C505C. This program demonstrates h
012dianji
- 该程序简单介绍了一种驱动微型电机的方法，大片机选用的是AT89C52，驱动电路选用的东芝的TA7267BP-the simple introduction of a micro-motor-driven, large machine uses the AT89C52, Driving circuit of the selected Toshiba TA7267BP
SH501
- 本程序介绍单片机作为信号发生器，来产生不同频率的正弦波、矩形波等。-procedures on the SCM as a signal generator to produce different frequency sine wave, square wave, and so on.
SH502
- 本程序简单介绍了给予单片机的低频信号发生器-the simple procedure of granting SCM low frequency signal generator
SH505
- 本程序介绍了方波频率的检测和备品方法，及信号滤波的简单方法-the procedures of the square wave frequency detection and spare parts, signal filtering and simple method
msp430_nRF905
- msp430和nrf905的例子,联系qqliuyong007@163.com-Controller and nrf905 example, Contact qqliuyong007@163.com
cesffffsfesfesf
- 产生级数为4的M序列，P1输入4个初值，在数码管上显示出来，单片机模拟产生伪序列码-produce series for the M-4 sequence, P1 four initial input, the digital control on the show. SCM simulation of pseudo-sequence code
jqereresrer
- 计算一组序列的游程数（序列长度为16），并在数码管上显示，用89S51实现-calculated a sequence of run-length (the length of the sequence of 16), and the digital pipe, used devised to achieve