资源列表
CC1110-4
- CC1110定时器T1使用试验，有兴趣的可以看一下-CC1110 Timer T1 using the test, a look of interest
CC1110-10
- CC1110的片内温度试验，有兴趣的可以看一下-CC1110 chip temperature test, a look of interest
keyboard
- 单片机键盘扫描程序，采用循环扫描的方法实现4*4键盘，适用于KeilC-Keyboard for scanner, using circular scanning method to achieve 4* 4 keyboard for KeilC
main
- 单片机 实现GPRS 发信息 实现通信 程序源代码-MCU GPRS send information source communication program
btljsgs
- 波特率计算工具.rar C++Builder编写的计算工具，计算51单片机串口波特率和初值-Baud rate calculation tool. Rar C++ Builder calculation tool written to calculate the initial value 51 and the microcontroller serial port baud rate
Neural_Network_Controlled_Energy_Saver_for_IM__1_
- neural network base system for parameters
AnalogConvertDigital
- 利用三种方式编程实现MC9S12XS128单片机AD转换功能。-Three ways to use microcontroller programming MC9S12XS128 AD conversion.
msp430_assemblely_instruction
- MSP430的汇编指令的集合， 并且有相应的源码可以参考进行学习-MSP430 instruction set of the assembly, and the corresponding source code can refer to learn
demo_6_4
- AVR单片机 mage16 基本程序练习 适合初学者-AVR microcontroller for beginners to practice basic procedures mage16
demo_5_1
- mage16 基本原程序练习 对初学者有很大帮助-mage16 basic original program very helpful for beginners to practice
nRF2401
- nRF2401芯片做接收端工程文件，使用MSP430单片机，运行稳定的测试程序-nRF2401 is used as a receiver which is controlled by MSP430 processor in this project, it works steadily,and is very appropriate to be tested by beginers of this chip!
KeyScan
- 4*4键盘扫描程序，本程序默认键盘总线接到P2端口，并且把P2口的低四位作为X坐标，高四位作为Y坐标。如不是用P2口做键盘总线，修改“KEYBUS”。-4* 4 keypad scanner, the program received a default keyboard bus port P2 and the P2 port four as the X coordinate of the low and high four as the Y coordinates. If it is not