资源列表
12_8
- 自己现在用的51系列单片机下载线，用74HC373芯片 PCB-himself with the 51 series microcontroller downloaded line with 74HC373 chip PCB
two_AD_show
- 本代码在凌阳单片机的编译环境下执行,主要实现的功能是双通道AD采样显示-the code in the compiler Sunplus SCM environment implementation, the main function is a two-channel AD sampling shows
LED164new
- 该程序主要实现通过74ls164实现串行驱动LED并显示,这种显示方法的LED量度较大-the main procedures adopted 74ls164 Serial LED driver and showed that This method showed a larger measure of LED
SetIOBit
- 该程序支持凌阳单片机的编译环境,主要实现对单片的某个端口进行置位-supported Sunplus the MCU compiler environment, the main achievement of a single portal in the home -
ad
- 这是一个AD转换程序,可实现多路AD转换,其运行是基于凌阳的spc061A单片机-This is an AD converter, which enables multi-channel AD converter. its operation is based on SCM Sunplus the spc061A
0000dao9999.asm
- 采用8051单片机驱动四位数码管的定时器系统。采用keil编译-used 8051 four-driven digital control timer system. Compiled using keil
cx
- 89s51单片机控制的键盘和led系统，键盘送数led从低到高位的显示-89s51 MCU control of the keyboard and led system, the keyboard to send a few led from low to high Show
11
- 具有固定的“红灯—绿灯”转换间隔，并自动切换。它们一般由“通行与禁止时间控制显示、红黄绿三色信号灯和方向指示灯”三部分组成。在交通灯的通行与禁止时间控制显示中，通常要么东西、南北两方向各50秒；要么根据交通规律，东西方向60秒，南北方向40秒，时间控制都是固定的。交通灯的时间控制显示，以固定时间值预先“固化”在单片机中，每次只是以一定周期交替变化。-having fixed the "red light-green light" switch partitions, and
jp4
- 单片机控制键盘和led，键盘送入的数据在led 上显示，数据满四位后，键入的第5位数据在个位显示，前四位清零。-MCU control the keyboard and led, keyboard into the data led the show, data-4, Type the first five places in the data revealed that four former reset.
clock20
- 基于12887和80c52的时钟程序，c语言开发 -based on the 12887 and 80c52 clock procedures, c-language development
key
- 单片机开发, 单片机开发-MCU Development, microcontroller development, the development of microcontroller, microprocessor development, the development of SCM
9s12forpwm
- 此程序是用9s12单片机控制直流电机的控制程序，已在实物上调试通过。包含PWM程序、通信程序等-this procedure is 9s12 MCU control of the DC motor control procedures, the physical debugging through. PWM includes procedures, communication procedures, etc.