资源列表
i2c
- 实现i2c主机开始，发送数据，地址，响应，结束。里面的子函数是在FPGA上测试过的代码。适合单片机作为主机向从机发送数据-i2c master to send or read data
Battery-charge-control-circuit-Online-Design-nd-An
- Battery charge control circuit Online Design and Analysis
xx
- 遥控和单片机光敏电阻数据采集，PC串行通讯-Remote data acquisition and SCM photoresistor, PC serial communication
etpu2
- 飞思卡尔MPC5634单片机，实现etpu通道0和通道1的PWM输出，用CodeWarrior2.6调试通过，对学习etpu的输出功能有很一定的帮助。-Freescale MPC5634 microcontroller, to achieve etpu channel 0 and channel 1 of the PWM output, with CodeWarrior2.6 debugged, the output of learning etpu There are some help.
xl345
- 采集ADXL345加速度数据的代码,采用ADUC760232位单片机-Analog Devices ADXL 345 digital output accellerometer
i2c_sw_8051
- i2c read and write function for 8051 ic type u can use 24c04 or other eeprom
timer0_8051_keil
- tish code for 8051 using timer0
temp
- 基于单片机温度测量控制及高温报警系统汇编-Control based on temperature measurement and high-temperature alarm system
indication
- 用单片机实现温度远程显示的单片机类毕业设计-Remote temperature display using MCU Graduation
AdminMonitor
- Profichip’s VPC3+S is a communication chip with 8-Bit parallel processor interface for intelligent PROFIBUS DP-Slave applications. Alternatively an SPI or I 2 C interface can be used to communicate with the chip.
EventLogReport
- Control Parameters (Latches/Registers) These cells can be either read-only or write-only. In the Motorola Mode the VPC3+S carries out ‘address swapping’ for an access to the address locations 00H - 07H (word registers). That is, the VPC3+S i
frquence
- 用C51自编的频率计程序 附带了proteus图 仅供体会用 能说明传统的测频发没有实际运用意义-80c51 frquence