资源列表
lcd12864zk_0a
- 12864液晶并行显示实验，利用51单片机控制KYN12864液晶显示图片，文字等。-It s a program of 12864 LCD parallel display experiment
dianti
- 电梯程序，可以模拟电梯的上下行工作，还可以进行设置楼层高度等功能-Elevator program can simulate the work of up and down the elevator, you can also set a high floor functions
CAD
- 文章，有控制系统的问题主要是仿真和控制器设计的东西-Article, there is the problem is that the control system simulation and controller design things
Ocm19264
- OCM192×64点阵液晶屏显示程序 金鹏电子-OCM192 × 64 dot matrix LCD display program Jinpeng Electronics
C8051F020-read-24c16
- C8051F020读取24c16存储器程序代码-C8051F020 read the 24c16 memory code
adc
- 是一篇关于360单片机AD的程序。自己编的。还算可以-It is a chengxu about 360 s ADC
source_avr
- nRF24L01 AVR的驱动程序,很完整 注释详细-nRF24L01 AVR source
switch-control12864LCDl
- 基于51单片机和2864LCD的开关串行模式显示-51 And 2864LCD based on serial mode switch display
DS18B20temperature-sensor
- 基于51单片机和DSB18B20的温度传感器实验源程序-51 And DSB18B20 based temperature sensor test source
the-watchdog
- 基于AT89S51单片机的看门狗技术的实验源程序-AT89S51 microcontroller technology based on the experimental source Watchdog
74LS138application
- 基于51单片机和74LS138译码器的应用程序-51 And based on the application 74LS138 decoder
SCM-C-language-program-timing
- 利用定时器0工作方式1，在开发板上实现第一个发光二极管以1ms为周期的闪烁。新建文件夹，程序代码如下所示-Timer 0 Mode 1 use of the work in the development of on-board LEDs to achieve the first cycle of 1ms for the flash. New folder, the program code is as follows