资源列表
mcu-and-ad
- 单片机与串行AD转换器TLC0834的接口设计-Microcontroller with AD Converter TLC0834 Serial Interface Design
ad-sample
- 基于AT90S8515_和USB_接口数据采集系统-AT90S8515_ and USB_ interfaces based data acquisition system
X5045-sample
- X5045例程,很详尽的一片汇编语言代码-X5045 routine, a very detailed piece of assembly language code
light
- 在单片机开发板上实现的数码管点亮程序。包括四个数码管，显示数字等内容。-In the SCM development board on the realization of digital tube light program. Includes four digital tube, display Numbers, etc.
DHT11
- 单总线技术应用于温湿度传感器DHT11,线路简单，开销硬件少-Single bus technology for temperature and humidity sensor DHT11, simple lines, less hardware overhead
MCU51-C_language
- 这是一本关于51单片机C语言的编程入门教程，很适合初学者使用-This is a single chip on 51 Tutorial C Programming Language, it is suitable for beginners
Photoshop-CS5-Read-Me.pdf.tar
- Manual for Adobe photoshop CS5 extended edition
MCU51-Programme-
- 整理了我自己编写的一些51单片机C语言程序，里面有数码管的代码，DS18B20的初始化，红外传感器的初始化，液晶、步进电机I^2C总线等一些程序-Written compiled some of my own microcontroller C-51 program, which has digital code, DS18B20 initialization, the initialization of infrared sensors, LCD, stepper motor I ^ 2C b
PCA
- PCA捕捉模块0的CEX0被设置在按键S3对应的引脚上，按下和松开S3，将会产生下降和上升沿信号，引发捕捉模块动作。-PCA Capture Module 0 CEX0 S3 is set the corresponding pin in the key, press and release the S3, will result in decline and the rising edge signal capture module trigger action.
lcd
- 1602A LCD显示程序,运行程序LCD显示"BT F310 V1.0",SPI接口方式的NLSF595并行输出 控制LCD-1602A LCD display program, run the program LCD display " BT F310 V1.0" , SPI parallel interface mode of NLSF595 LCD output control
key
- 按键测试程序.按下S1-S4,在LCD上分别显示1-4 实验时短接J17的1,2引脚(LCD电源控制引脚)-Key test program. Press S1-S4, 1-4 in the LCD display on the experiments were short the pins 1,2 J17 (LCD power control pins)
比较器CP0+来自于VREF引脚
- 此程序可完成CP0比较器的比较功能，比较器CP0+来自于VREF引脚,CP0-由S2控制.按下S3后,比较器响应后将产生中断,可在中断程序中设断点观察.-This program can be completed relatively CP0 comparator function, the comparator from the VREF pin CP0+, CP0-controlled by the S2. Press the S3, the comparator generates an