资源列表
Labview.vi
- LabVIEW做的一个虚拟示波器的源代码- LabVIEW to do the source code of a virtual oscilloscope 朗读 LabVIEW to do the source code of a virtual oscilloscope 朗读
dongtaishaomiao
- 用51系列的单片机控制，在6位数码管动态显示3位秒表。从000开始变化，到999.-MCU control with 51 series, the six LED dynamic display of three stopwatch. Began to change from 000 to 999.
frequency_test_avr
- AVR做的频率计，基ucOS2操作系统.测频范围 10Hz-60 Khz。测量精度高，范围大。-AVR to do the frequency, the operating system based ucOS2,welcome to read when you are studying AVR microcpu.
quick_PWM
- 基于AVR单片机Mega128做的PWM波形产生程序，利用定时计数器的快速PWM产生功能。用于波形产生，信号发生。-Mega128 AVR microcontroller based PWM waveform generation program to do, use the fast PWM timer counter generating function. For waveform generation, signal.
CTC_wavegenerate
- 基于AVR单片机Mega128制作的CTC波形产生源码，主要用于波形发生，信号产生。-AVR microcontroller based on the production of CTC Mega128 source waveform generator, mainly used for waveform generation, signal generation.
ucos8563
- 基于AVR单片机Mega128和开源操作系统ucos/2编程的时钟程序，主要用于制作日历，记录时间的情况-Mega128 AVR microcontroller based and open source operating system ucos/2 programming clock procedures, mainly for the production of the calendar, the case of recording time
relay
- 基于AVR单片机Mega128和ucos/2操作系统的编辑的继电器程序，主要用于程控继电环境-AVR microcontroller based Mega128 and ucos/2 operating system, editor of the relay program, mainly for environmental program-controlled relay
multi-byte-division
- 51系列单片机的多字节除法，提供两个程序。一是四字节除四字节，二是双字节除双字节。-51 series of multi-byte division, provides two programs. The first four bytes than four bytes, the second is double-byte double-byte addition.
Protel99sepackage
- protel99se是常用的电路板制版软件这次上传的是最多最全的protel99se下的封装库。-Protel99se the most complete package under the library.
disp
- 一个采用霍尔器件的流量传感器的并采用数码管显示的程序。-A flow with Hall sensor device and using digital display of the program.
stc51asm
- 这是STC单片机实验板的测试程序加上实验板的仿真图，原创啊，可以运行的。-This is the STC microcontroller test board with test board test program simulation map, original ah, you can run.
c51controlFPGA
- PWM控制直流电机FPGA驱动,可以使用按键控制，加速、减速、正转、反转、停止-FPGA-driven DC motor PWM control, you can use the button control, acceleration, deceleration, forward, reverse, stop