资源列表
digitron-calculator
- 计算通用8段数码管段选数组工具。是开发单片机的好工具！-Tool to calculate digitron selection.
ershisizhijishi
- 本程序为用C语言控制单片机实现二十四小时制不可控计时-This procedure for the use of C language control MCU system clock time is not controllable
miaobiao
- 能精确到0.01秒的秒表，能支持按键停止功能-To the stopwatch accurate to 0.01 seconds, to support the stop function key
sine
- 通过51单片机和DA实现几种常见波形，并通过键盘控制，液晶显示-AT89S52 DAC KEY LCD1602
bujindianji
- 控制步进电机正转，反转，停止功能。用stc89c52控制-Stepper motor control forward, reverse, stop function. Controlled by stc89c52
lcd01
- stc89c52的液晶屏动态显示源程序。加管脚说明-stc89c52 LCD screen dynamic display source. Add pin descr iption
my_sub_1
- 实现上位机与单片机的串行通信来控制直流电机转动-Host computer and serial communication to control the DC motor rotation
8P1302
- 单片机89s52+8位数码管+ds1302 源C-Microcontroller 89s52+8 bit digital source C+ ds1302
51calc_25keys
- 基于单片机设计的计算器,具有显示精确度高和常用的计算功能等-Calculator based on single chip design, has shown high accuracy and the calculation of common functions
51dpj
- 基于8051单片机的LED流水灯C语言设计源码-Water based on 8051' s LED light source C language design
P6
- 菜棚温度测量器的设计与仿真：在proteus软件环境下实现温度传感器DS18b20和字符液晶显示器LCD的应用及仿真汽。-Food shelf temperature measurement device design and simulation: The proteus software environment to achieve temperature sensor DS18b20 and character liquid crystal display LCD and Simulati
Sliding-Mode-Control-in-Engineering
- Document on Sliding mode control engineering. Contains all basic and advanced information that is required to gain knowledge in Sliding mode control for Simulink implementation.