资源列表
24C02_V2
- 本程序是对24C02的读写程序，用AM8EB单片机进行I2C通讯.-This program 24C02 read and write procedures using AM8EB microcontroller I2C communications.
bujiandianji
- 通过单片机来控制步进点击的转动，来改变点击的角度，从而控制其他东西-dianji funtion
DAO832
- 通过单片机来控制他们的八个IO口的高度点评，从而进行信号放大。-da ship funtion
shumaguan
- 通过单片机来控制数码管端口的高低电平，从而点亮数码管-dedio funtion
temperature-probe
- 通过单片机来控制温度传感器，来测量周围环境的温度-temperature probe
PowerU
- 移动版智能充电器，非常成熟的的一个产品，可作参考。-Mobile smart charger, a very mature product, can be used for reference.
jisuanqi
- 用诺基亚5110屏显示，来实现计算器的，单片机是STC11F32XE 按键中用到中断-Nokia 5110 screen display to the calculator, the microcontroller is used in STC11F32XE keys interrupt
lcd12864
- 单片机控制的12864液晶使用代码，采用并口控制方式。-Single-chip microcomputer control 12864 liquid crystal using code，The parallel control mode。
project1
- 程序功能：实现开关的检测将单片机P1口的高四位的变化状态在其低四位的二极管中显示出来。(Ps:专属于哈工大的大作业课件内附Proteus原理图)-The program features: the detection of the switching microcontroller the P1 port four changes state will show up in the low four diodes. (Ps: exclusively HIT operations coursewa
project2
- 通过按下K0，K1，K2，K3四个不同的键来控制LED发光二级管的显示规律。(哈工大单片机大作业内附proteus原理图)-By pressing K0, K1, K2, K3 are four different keys to control the regularity of the LED light emitting diode display. (HIT SCM operations included proteus diagram)
project3
- 8个二极管依次左移点亮，然后在依次右移点亮，如此循环(哈工大单片机大作业内附proteus原理图)-8 diode turn the left is lit, then shifted to right light, so the cycle (HIT the microcontroller large job included proteus diagram)
project4
- 流水灯的流水方向受两个键的控制。其中分为合上键，和按下键的四种状态 （哈工大单片机大作业内附proteus原理图）-Light water flow direction is controlled by two keys. Which is divided into closing the key, and press the key four states (HIT SCM operations included proteus diagram)