资源列表
alarmclock2
- 电子钟，可计数，计算器，定时闹钟，显示时间年月日-alarm clock
IIC
- 通过IIC总线的传输，将预先设定好的8个数值传到24C04芯片中，并转存，最后通过读取转存区的值，由流水灯显示出来。-IIC bus transfer preset good eight values reached the 24C04 chip and dump Finally, read the value of the dump area, displayed by light water.
chuanxingU2
- 设计两片C51单片机，U1作为接收机，U2作为发送机，U1接收U2发送的数据后，依次送P0/P1/P2口进行流水灯显示，流水灯循环亮灭-Designed the two C51 microcontroller, U1 as a receiver as a transmitter, U2, U1 receives U2 send the data, in turn send P0/P1/P2 mouth water lights display, water cycle bright lights
zhinengchechengxu
- 飞思卡尔智能车各模块源程序，包括模块初始化和程序运行-Freescale smart car module source, including module initialization and program run
Infrared-demo
- *紅外測試程序，用單片機通過發射管發射38K的調製頻率碼，由一體化接收並解碼由發光管顯示。 *正常情況下，由於反射和高靈敏度接收，LED4（P1.3)一直閃爍，可以用黑色紙片完全遮擋接收頭使 *之不能接收到發射管的信號，這是LED4熄滅。說明功能性正常-* Infrared testing procedures, MCU through the launch tube launch 38K code modulation frequency is received and decod
Remote-control-transceiver
- 按遙控器上1-9會發射紅外線 而接收後在數碼管上對應顯示-1-9 emits infrared remote control receiver corresponding digital tube display
Remote-control-driver
- 按遙控器上1-9會發射紅外線 而接收後在數碼管上對應顯示-1-9 emits infrared remote control receiver corresponding digital tube display
Thermistor-test
- 使用1路ad測試熱敏電阻阻值，並查表得到溫度值，溫度精度和多種參數有關。-Road ad test thermistor resistance, and look-up table to get the temperature value, temperature accuracy and a variety of parameters relevant.
DADMA
- 430信号发生器。通过DMA和DA模块输出，256点最大频率可达7.8KHZ-430 signal generator. DMA and DA module output, the maximum frequency of up to 256 points 7.8KHZ
Photoresistor-test
- 使用4路AD中的1路檢測外部模擬量輸入，顯示0-255數值-1 channel in the 4-channel AD detection external analog input, display 0-255 value
lcd12864
- MSP430 并行控制LCD12864显示-The MSP430 parallel control LCD12864 display
LCD-AD---DA
- 此程序通過IIC協議對DAAD芯片操作，讀取電位器的電壓通過液晶顯示，並輸出模擬量，用LED亮度漸變指示-This program through IIC protocol DAAD chip operating voltage reading potentiometer LCD output analog, with LED brightness gradient indicates