资源列表
nRF24L01-01
- nRF24L01收发一体代码。两块单片机的程序一模一样，程序确定能用，没调通的查找硬件原因。-nRF24L01 transceiver code. The two MCU program exactly the same procedures to determine can not tune through to find the hardware reasons.
nRF24L01-02
- nRF24L01，4个同时发送一个接收。程序确定能用，没调通的查找硬件原因。-nRF24L01, 4 simultaneously transmits a receive. Determines can not tune through to find the hardware reasons.
mcf52259PLL-48Mhz-to153.6Mhz
- mcf52259芯片，用48M晶振通过PLL配置超频到153.6MHZ，内涵详细代码和注释-mcf52259 chip crystal oscillator with 48M PLL configuration overclocked to 153.6MHZ, connotation detailed code and notes
lcd
- 此文件介绍了使用AVR单片机控制LCD屏的方法,代码祥细,是学习的好资料.-This document presents the AVR microcontroller to control LCD screen, Xiangxi code, learning good information.
AD7731
- 51STC单片机驱动AD7731 24为AD芯片程序-51STC microcontroller driver AD7731 24 AD chip program
HUB08
- 最常用的三色LED接口图定义，所有引脚描述-The most commonly used definition of tri-color LED interface Figure, all pin descr iption
fengminqi
- 使用普通i/o驱动无源蜂鸣器，蜂鸣器应用-Use normal I/o drive passive buzzer
Keil
- 关于如何使用kiel的教程，有详细的描述关于C程序在kiel中的使用-Kiel tutorial on how to use a detailed descr iption on the use of C programs in the kiel
AD
- 串行AD转换实例，51单片机控制。 使用TLC549转换。C语言编写程序。-Instance, 51 single-chip serial AD converter control. Using TLC549 conversion. C language programming.
stm_32_circle_countTime
- 智能小车分圈计时器的设计。利用STM32为核心处理器，以红外对管检测外界物体，触发外部中断启动计时，利用内部定时器中断实现精确到小数点后两位的计时，并通过LED显示出当前的时间。-Design smart car sub lap timer. Utilize the STM32 core processor, infrared tube to detect external objects, trigger external interrupt start timing, internal ti
jk
- 智能小车的设计，小车能自动循线运行、加速、停止-The design of the smart car, the car can automatically run through the line, accelerate, stop
key_led_Demo
- ARMLPC2148开发板光盘资料-09新教程-led程序原码，希望对大家有点帮忙-CD-ROM-09 ARMLPC2148 development boards new tutorial-led program source code, we want a little help