资源列表
16x64LeD-in-51
- 基于51单片机串口的16*64点阵广告屏proteus仿真带程序-16*64led display in 51microprocessor and 74hc595
4.1---TFT_LCD
- 本代码成功实现了MPU方式驱动16色的TFT屏，包含完整程序。-This file can drive an 16 color TFT successfully ,here is the whole code in MPU driving mode .
stm32_sw_i2c
- 此代码实现的是STM32系列芯片的软件模拟I2C读取光感。-This file use GPIO to modulate I2C to read an lightsensing IC with STM32 series.
src
- BQ24765充电芯片SMBUS通信设置，要的赶快。-The BQ24765 the charging chip SMBUS communication set to hurry.
mcd-epm1
- PIC16F87 内部EEPROM读写实验-The PIC16F87 internal EEPROM reading and writing experiments
ADC
- PIC16F87用数码管显示的单通道模拟量采集器-The PIC16F87 with digital display of single-channel analog acquisition
mcd-93C46
- PIC16F87X软件模拟SPI方式读写93C46-The PIC16F87X software simulation SPI way to read and write 93C46
song
- PIC16F87实现音乐播放程序 通过驱动实验板上的蜂鸣器发声，实现音乐的播放。 -The PIC16F87 music player through the drive experimental panel buzzer sound, music playback.
mcd-lcd1
- LED8位流水灯 本程序实现的功能是，把端口RC的8条引脚全部设置为输出模式，依次从引脚RC0 到RC7送出高电平，然后再依次从引脚RC7到RC0送出高电平，并且周而复始，从而 使得与该端口C相连的8只发光二极管LED循环依次点亮，其效果类似于一个简单的霹雳灯-The functionality of this program LED8 bit light water 8 port RC pin is set to output mode, turn sends a high lev
mcd-lcd2
- 单键触发8位二进制累加计数器 该程序的功能是把演示板当做一个按键计数器。刚刚接通电源时，8只发光二极管都不亮。表示计数器初值为0，当按下开关S3（RB0）时，计数器的值加1，发光二极管D3点亮，表示值1，然后松开按钮；再次按下开关S3（RB0）时，计数器的值又加1，发光二极管D4点亮，表示值2，依次类推，反复循环-One-touch function to trigger the program of the 8-bit binary up-counter demo board as a k
Traffic_Lights_for_Method
- SystemC实现交通灯控制，用状态机的方式通过Method进程控制方式实现Thread进程控制方式-SystemC for traffic light controling
FATFS_SD
- 一个FATFS文件系统的代码，以SPI模式读写SD卡。有完整的IAR工程文件。-A FATFS file system code, SD card SPI mode to read and write. Complete IAR project files.