资源列表
STM8S105s4
- STM8S105S4 时钟切换, 切换到外部晶振 用STVD开发环境,C语言编程 -The STM8S105S4 clock switching, the switch to an external crystal with STVD development environment, C language programming
led
- 停车场十字路口LED灯引导程序，自动设定路径！-The parking the crossroads LED lights to guide the program to automatically set the path!
DZ60-213(LAO)
- 飞思卡尔CAN例程，助你快速掌握CAN,了解CAN协议，CAN实现办法-Freescale CAN routines, to help you quickly master CAN understand the CAN protocol, CAN achieve way! ! ! !
DMX512
- 本程序用于实现DMX512为接收,DMX512信号自动识别-This procedure is used to achieve DMX512, DMX512 signal to receive automatic identification
ourdev_598678PTMEFK
- 串行FLASH_W25X40_读写程序范例。。立即可以使用哦-Serial read and write FLASH_W25X40_ procedures example.. Immediately you can use the oh
cd4021Pprotues
- aTmega8驱动CD4021,实际程序为74165程序，在P/S口加反相器。 在实际电路中应注意TTL与CMOS电平转换-aTmega8 drive CD4021, and the actual procedure for the 74165 program, plus the P/S port inverter. TTL and CMOS level conversion should be noted that in the actual circuit
lcd
- ARM9的MINI2440开发板的LCD裸板程序，韦东山课本带的-The ARM9 development board LCD bare MINI2440 board program, Wei Dongshan textbooks with
gen
- 遥控小车的跟踪程序，分别定义左右信号，左信号为假时向右转，有延时程序。-Remote control car track program, define the left and right signal, left and right turn signal is false, the delay procedure.
netsd
- 工业以太网单片机络模块程序，并且具有MP3 sd卡模块-Industrial Ethernet single-chip network module program
164LED
- 仿真串口发送74LS164接收驱动LED ,51单片机的开发，利用串入并处的接口来提升Io口的效率-Serial port emulation send 74LS164 reception drive LED 51 microcontroller development to enhance the use of the string into and impose interface Io mouth efficiency
clockandtemperature
- 51单片机实现调节并读取时钟芯片DS1302和温度传感器18b20的数据并在液晶1602上显示。-51 single chip microcomputer control and reads the clock chip DS1302 and temperature sensor and b20 data and in the liquid crystal display on 1602
I2C_24C01
- 实现AT24C01的读写，利用软件仿真察看结果。-AT24C01 read and write back the results of the use of software simulation.