资源列表
3264LED_BAN
- 双色LED显示屏08接口,字库快一岁时更改，显示稳定，，STC895A60S2 金正27M32*64-The two-color LED display 08 interface, the font one year old, faster change display stable, STC895A60S2 Kim Jong 27M32* 64
NAT9914source
- GPIB 9914驱动源码；主要针对GPIB器件的开发-GPIB 9914 driver source code
18B20
- 对11.0592MHZ的单片机，通过18B20温度传感器读取温度，然后和通过串口回传给计算机读取温度-11.0592MHZ microcontroller, 18B20 temperature sensor reads the temperature, and then read the temperature and passed through the serial port back to the computer
DS1302
- 通过对IC DS1302写入时间，然后IC自动完成时钟运行，然后单片机从IC中读出时间，在通过串口回发数据给计算机，按照中国人读时间的习惯显示-By IC DS1302 write time, then the IC automatically complete the clock running and microcontroller time read out from the IC in through serial postback data to the computer, in ac
28-999
- 通过定时器来计算时间，然后接收串口发送数据并自动累加到1000在重新从0开始-Timer to calculate the time, and then receives the serial port to send data and automatically added to the 1000 in the re-start from 0
bujinmadashiyan
- keil环境下，用c51单片机实现对步进马达的单双八拍的程序驱动，c语言程序编写” -stepper motor odd and even eight-beat program keil environment, c51 microcontroller drive c language programming
SPI1
- stm8单片机，spi数据总线协议，已经过调试，一切正常。-stm8 microcontroller the spi data bus protocol has been commissioning, everything is normal.
1602xianshijianzhi
- c51程序，通过按键控制1602液晶屏显示，用c语言编写。-c51 procedures, through the control button 1602 LCD display, using the c language.
315wuxian
- 51单片机，315无线程序，由315接收端及315发射端组成。对应控制程序。-51 single-chip, 315 wireless program, 315 receiving end and 315 transmitter end. Corresponding to the control program.
bootloader1280
- ATMEGA2560的BOOTLOADER程序-The ATMEGA2560 The BOOTLOADER program
four-tracking-program-code
- 51单片机四路循迹模块的程序代码，内含keil uv3工程文件，直接编译下载即可-51 microcontroller module of four tracking program code containing keil uv3 project file, compiled directly download can
12864I_lcd
- 本程序是控制低功耗的液晶显示的C程序，液晶功耗在4毫安，3.3V.-This procedure is controlled by a low power consumption of the liquid crystal display of the C program