资源列表
home_control
- 智能家居控制。系统软件设计部分主要由五大部分构成:即数据采集与数据分析部分。-Smart home control.System software design is mainly composed of five major components: data acquisition and data analysis section.
code
- 51单片机中制作安防遥控器,利用红外解码原理编程。-51 single-chip production security remote control using infrared decoding principle programming.
at24c02_05
- 51单片机中通过i2c总线读写at24c02,利用i2c时序进行编程封装读写函数。-51 MCU by i2c bus read and write the at24c02, i2c timing programming package to read and write function.
lcd1602_04
- 51单片机读写DS18B20的温度,通过单总线时序进行编程,在lcd上显式出来-51 SCM reader DS18B20 temperature programmed through a single bus timing, explicitly come out in the lcd
DS18B20-temperature-measurement
- 基于DS18B20的单片机开发程序,给出了详细的C语言代码,以及详细的C语言注释-DS18B20-based microcontroller development program, given the details of the C language code, and the C language comments
2.monikaiguandeng
- 监视开关K1(接在P3.0端口上),用发光二极管L1(接在单片机P1.0端口上)显示开关状态,如果开关合上,L1亮,开关打开,L1熄灭。-The monitor switches K1 (connected to the the P3.0 port on), light-emitting diode L1 (connected to the microcontroller on the P1.0 port) display switch status, if the switch is clos
3.duolukaiguanzhuangtaizhishi
- AT89S51单片机的P1.0-P1.3接四个发光二极管L1-L4,P1.4-P1.7接了四个开关K1-K4,编程将开关的状态反映到发光二极管上。(开关闭合,对应的灯亮,开关断开,对应的灯灭)。-AT89S51 microcontroller connected to P1.0-P1.3 four light emitting diodes L1-L4, P1.4-P1.7 pick up the four switches K1-K4 programming the switch status
4.-guanggaodengdezuoouyi
- 做单一灯的左移右移,硬件电路如图4.4.1所示,八个发光二极管L1-L8分别接在单片机的P1.0-P1.7接口上,输出“0”时,发光二极管亮,开始时P1.0→P1.1→P1.2→P1.3→┅→P1.7→P1.6→┅→P1.0亮,重复循环。-Shift left shift right, do a single lamp hardware circuit as shown in Figure 4.4.1, eight light-emitting diodes L1-L8 respectively
5.guanggaodeng_qubiao
- 利用取表的方法,使端口P1做单一灯的变化:左移2次,右移2次,闪烁2次(延时的时间0.2秒)。-Take the table, do a single lamp port P1 changes: left, right by 2 flashes 2 times (delay time of 0.2 seconds).
MI_CR
- 以前发现的一款电脑声卡示波器软件,发现还不错,就破解了,在这里在这里分享给大家,软件是虚拟示波器-Multi-Instrument3.2-Previously found a computer sound card oscilloscope software, found a pretty good crack share here for everyone here, the software is a virtual oscilloscope-Multi-Instrument3.2
mcuelf
- 单片机小精灵最新版,支持STC1T单片夹,破解了拿出来给大家分享-Microcontroller elf latest version support STC1T monolithic folder, cracked out to share
Coffee-machine-with-HT48R06
- HT48R06的智能咖啡机设计,包含软硬件设计说明。-Coffee machine coffee machine, do with HT48R06 microcontroller.
