资源列表
ChaoShengBo
- 基于8051的超声波测距系统，多路AD转换。内附详细注释-8051-based ultrasonic ranging system, multi-channel AD converter. Included detailed notes
430PID
- 430单片机通过PID控制温度,精度0.3-430 microcontroller PID temperature control accuracy of 0.3
SWIMMING-TIME-CONTROL
- 游泳导航仪，将世界纪录值设入，训练训动员-Swimming navigator, set the world record for value, training, training mobilization
RS232shuangji
- RS232双机通信程序，经硬件测试通过，内附电路图和详细注释-RS232 dual-machine communication program, hardware test by enclosing the circuit diagram and detailed notes
5
- 将立即数0x5A写入地址为0x00的EEPROM单元，然后将EEPROM地址为0x00的数据读出，验证其是否为0x5A。如果是则点亮实验套件电路板上的LED0，如果读出的数字不是0x5A则点亮LED1.-Immediate 0x5A write address is 0x00 EEPROM cells, then the data EEPROM address 0x00 read out, to verify whether 0x5A. If it is light up the experim
6
- 用实验电路板上的PIC16F877A控制一个发光二极管来模拟航标灯工作。模拟航标灯以精确的1Hz频率闪烁，其中关闭时间为0.5s，发光时间也是0.5s。要求1Hz闪烁频率的长期误差达到20ppm以下。-Breadboard PIC16F877A control to simulate a light-emitting diode beacon lights work. Analog beacon lights to the precise frequency of 1Hz blinking, c
7
- 用SPI总线将两块实验电路板连接起来。作为SPI主机的PIC单片机读取其所在的实验电路板上的按键值，判断6只按键中的哪一只被按下，并将按键编号通过SPI总线发送给作为从机的PIC单片机。从机得到按键编号后点亮从机所在电路板上对应的发光二极管，并将收到的按键编号重新发还给主机。主机收到后也将所在电路板上对应的发光二极管点亮。-Two breadboard connection with the SPI bus. Read key value of its experimental circuit
Juzhengjianpan
- 基于8051的单片机矩阵键盘C程序内附详细注释和电路图-Based on the 8051 microcontroller matrix keyboard C program included detailed notes and schematics
MP3playerC51
- 单片机实现MP3播放的程序，基于8051，速度较慢，但能播放确实不错了-MCU MP3 player in the program, based on the 8051, slower, but can play really good
clock-and-temperature-and-LCD1602
- 单片机程序，时钟程序，温度测试和LCD显示-Microcontroller program, clock procedures, temperature test and LCD display