资源列表
puzhongkeji-danpianjicx
- 普中科技 实验箱单片机程序有c和部分汇编程序-S & P Technology Experiment Box microcontroller program
duquDS18B20
- 单片机读取温度传感器DS18B20的值，已经调试过，板子搭起来工作正常，放心使用-Microcontroller to read the value of the temperature sensor DS18B20, has been debugged, the board take up normal work, ease of use
CC2430-1
- CC2430-1 本次实验的目的是让用户学会使用CC2430 的I/0 来控制外设，本例以LED 灯为外设，用 CC2430 控制简单外设时，应将I/O 设置为输出。实验现象是绿色LED 闪烁-CC2430-1 of this experiment is to allow users to learn to use the CC2430 I/0 control peripherals, peripherals, with LED lights the CC2430 control si
CC2430-2
- 让用户掌握CC2430 的按键应用这一常用人机交互方法，本次实用两个分别控制两个LED灯。-Button for the user to grasp the CC2430 application of this common human-computer interaction, this practical two control two LED lights.
love
- 单片机分开发板中8*8点阵显示“love”的一个爱心图案-MCU sub-development board 8* 8 dot matrix display " love" of a pattern of love
CC2430-3
- 这个实验中使用按键控制LED 或闪烁，或熄灭。-This experiment using the control button LED or flashing, or off.
CC2430-4
- 用定时器1 来改变小灯的状态，T1 每溢出两次，两个小灯闪烁一次，并且在停止闪烁后成闪烁前相反的状态。-Timer 1 to change the status of a small lamp, T1 overflow twice each, two small lights flash once, and stops flashing before flashing to the opposite state.
CC2430-5
- 用定时器2 来改变小灯的状态，T2 每发生一次中断小灯改变状态一次。-Timer 2 to change the status of a small lamp, T2 occurs once every interrupt lights change state once.
CC2430-6
- 用定时器3 来改变小灯的状态，T3 每发生200 次中断小灯改变状态一次。-To change the status of a small lamp timer T3 interrupt occurs 200 times small lights change state once.
smartcar
- 基于飞思卡尔单片机XS128开发的整车程序-Based on the the Freescale microcontroller XS128 development of vehicle program
sd
- SD卡读写与Proteus仿真-SD card reader with Proteus simulation
dianzhicheng
- 使用keil uvision编写的一个简单智能电子称程序，除了测量重量外，可以检测串口连接是否成功，可以判断物体是否超重。-A simple intelligent electronic use keil uvision write the said program, in addition to measuring the weight, you can detect the serial port connection is successful, you can determine whe