资源列表
CC1020
- cc1020控制程序！ 测试问题的！ 可以收发，-good CC1020 PROGRAMMER
AT89c52
- 用AT89C52实现的核废弃监测仪,自己写的，已经在用了，-AT89C52 to nuclear waste with the monitor, he has written, has been used, huh, huh
Exp12_LCD_Test
- 基于SOPC的液晶显示，运用640*480单色屏，建立SOPC Builder硬件设备，在NIOS环境下编写软件程序-SOPC-based liquid crystal display, the use of 640* 480 color screen, the establishment of SOPC Builder hardware environment in NIOS software program written
DS18B20
- 单片机 ds18b20 1602 lcd-SCM ds18b20 1602 lcd
SiliconLabsinterface
- Silicon Labs公司的2线接口应用的详解-Silicon Labs 2-wire interface applications company Wapakhabulo
1234
- 能智能小车设计论文(电路+程序+论文)，可以自己动手做一个电动车-To smart car design thesis (circuit+ program+ papers), can be an electric car DIY
F020ADC
- F020单片机的ADC0采样程序（使用中断）-F020 MCU ADC0 sampling procedures (using interrupts)
key_test
- 通信系统大型实验板上有4个按键，分别为K1、K2、K3、K4，相对应的管脚为PIN46、PIN47、PIN48、PIN49，按下按键K1、K2、K3、K4（定义为key）用示波器或万用表观测被控制的输出端口（定义为tpin）变化，应有电平跳变-Large-scale experiment on-board communication system with 4 keys, respectively, K1, K2, K3, K4, corresponding to the pin for the
ys
- 两路单极性HDB3+和HDB3-信号，经映射模块后完成单极性到双极性信号的数字转化，该模块由设计文件ys.v完成。由于映射后得到的是双极性归零码，通过该模块得到双极性非归零码。该模块由设计文件delay.v完成-Two unipolar HDB3-signals HDB3+, and by the mapping module to complete unipolar to bipolar signal digital conversion, the module completed by th
cal
- ATmega16 计算器 秒表 猜数游戏多合一 使用CVavr 调试-ATmega16 calculator stopwatch guessing game-in-one debug using CVavr
Cypress_SL811HS_SDK
- SL811HS（USB） 评估软件包,包括上位机（win,linux）,固件程序还有一些对应的资料-SL811HS SDK, including PC (win, linux), firmware and some corresponding information
ch451
- CVavr 环境下的ATmega16 ch451驱动程序 -CVavr environment ATmega16 ch451 driver