资源列表
24CXX
- I2C EEPROM 24C读写器源文件,一个读写程序-I2C EEPROM 24C reader the source file, a reading and writing program
Pont
- 基于时间触发嵌入式设计模式（8051）源码-Based on Time-Triggered Embedded Design Model (8051) Source
SY_OO7
- 数码管显示当前温度程序 适用于CC100C，若数码管上电后有残影，请将液晶显示器拔下后重新上电-Digital tube displays the current temperature procedure applies to CC100C, if the digital control power after stuttering, please unplug the LCD monitor and re-power
SY_002_2
- 数码管显示程序 显示87654321 采用中断扫描模式-LED display program displays 87654321 interrupt scan mode using
SY_003_1
- 串口通信 数码管显示发送和接受的数据 串口波特率96-Serial communication to send and receive digital tube display the data serial port baud rate 9600
89c51_read_sd
- SD文件系统驱动程序基于89c51,可以移植到其他芯片的文件系统-SD file system drivers are based on 89c51, can be transplanted to other chips, the file system
SY_003
- 蜂鸣器连续发出8次声响 适用于CC100A、CC100B、CC100C-Continuous buzzer sound issued eight times apply to CC100A, CC100B, CC100C
display_16bit_TP
- ili9328驱动IC驱动和简单显示程序-The sinple display programmer for the ili9328 driver IC
SY_004
- 按下按键AJ1后，引发外部中断0。 0中断触发后数码管显示 1-8 循环两次-After pressing the button AJ1 triggered external interrupt 0. 0 interrupt trigger LED display 1-8 after two cycles
34
- 利用单片机和两个按键控制步进电机智能正反转-The use of microcontroller and two buttons control the stepper motor Intelligent positive inversion
45
- 利用单片机控制步进电机正反转+加数码管显示-SCM control stepper motors using positive inversion+ plus digital tube display
56
- 利用单片机控制PS2键盘操作和数码管显示-PS2 keyboard operation single-chip computer control and digital control display