资源列表
ha0103s
- LCD控制器驱动,单片机下使用，也可用在其他嵌入式环境中.-LCD controller driver, microcontroller use, can also be used in other embedded environments.
mp3
- 红外遥控按下，4位LED数码管显示音乐的序号，并由喇叭演奏出相应序号的音乐，这里我们提供了12首的音乐，也就是序号从1到12，当我们按遥控器上面别的按键的时候，这时候系统要提示没有歌了，并显示错误的标志。相当于是一个midi播放器！-Infrared remote control is pressed, 4 LED digital tube display music, serial number, by the corresponding number of speakers playing
ds18b20
- 通过1820进行温度采集，然后并通过1806显示。-Temperature acquisition, and through 1806 show
SDebug(040317)
- 在电视板卡中，会有很多芯片在上面，CPU和主芯片之前是通过IIC来访问，或者直接寻址；实际工作中需要对各个芯片的寄存器进行读写； 此软件还能配合凌阳的SPV系列芯片实现在线升级的功能-The boards and on television, there will be a lot of chips on top, CPU and the main chip through the IIC to visit before, or directly addressing practical
8led
- 这是我经过修改仿真的8位数码管显示带闹钟的时钟程序，并且附带有仿真图。-This is my simulation of a modified 8-bit digital tube display with alarm clock program, and with a simulation of Fig.
SD
- 数独实现算法，刚刚从网上荡下来的，还没仔细分析。大家掂量着用-sudoku application , you can get or solve a sudoku puzzle with it
mmm
- 电机调速控制系统的设计，包括键盘、显示、pwm波的输出等功能-Motor speed control system design, including keyboard, display, pwm wave functions of the output
baojing
- 当检测到有险情就会拨通预先保存的电话号码-When it detects that there is danger it will dial a pre-stored phone numbers
Keil-C
- 通过传感器检测信号进行电话险情报警和声光报警-Telephone signals through the sensors to detect danger alarm
2051-1
- 倒计时 设置好倒计时的时间 启动后便可自动执行倒计时-Countdown to set a good time to start the countdown after countdown will be automatically
2051-2
- 当检测到的温度偏离正常时便通过单片机控制报警-When the temperature is detected when they deviate from the normal control of alarm through the MCU
SerAD8113
- Ad8113 驱动程序，三线控制，一次传输80bits，16*16通道切换。-Ad8113 driver, three-wire control, a transmission 80bits, 16* 16-channel switch.