资源列表
DA
- 将模拟的电信号转换成数字信号。在将物理量转换成数字量之前，必须先将物理量转换成电模拟量，这种转换是靠传感器完成的。-Will convert analog signals into digital signals. In the physical quantities into digital, you must first convert the electrical analog physical quantities, such conversion is done by sensors.
mcs_PWM
- 本方法的基本思想就是利用单片机具有的PWM端口，在不改变PWM方波周期的前提下，通过软件的方法调整单片机的PWM控制寄存器来调整PWM的占空比，从而控制充电电流-The basic idea of this method is the use of microcontroller has the PWM ports, without changing the PWM square wave cycle, under the premise of the method to adjust by s
segment
- mage8的数码管扫描程序 -mage8 digital control digital control mage8 scanner scanner
DCMotor
- 直流电机的单片机控制，可以在proteus下进行仿真-DC Motor Control MCU
18b20
- 单片机测温程序,可以测出-50到100度的温度，通过温度传感器-MCU temprature
StepMotor
- 步进电机的单片机控制，可以在Proteus下进行仿真-Stepper motor microcontroller control, can be carried out under the Proteus simulation
PWM
- 用单片机产生pwm波形的程序，可以在proteus 下进行仿真-Pwm waveforms generated with the microcontroller program can be carried out under the proteus simulation
TemperatuerMonitor
- 基于单片机的温度检测，可以用proteus进行仿真-Temperature detection based on single chip can be used proteus simulation
ADC
- 基于单片机的AD转换器，可以用proteus进行仿真-The AD converter based on single chip, you can use proteus simulation
CC430F613X_F513X_code
- CC430 系列单片机各部分资源的 DEMO 源程序，对于初使用该 IC 的同仁很有用的。-CC430 Series MCU resources in various parts of DEMO source code for the early use of the IC colleagues very useful.
msp430f5xx_userguide
- TI MSP430F5xx 系列 MCU 的 User Guide，各种资源都较前几系列丰富了很多。-TI MSP430F5xx Series MCU, User Guide, a variety of resources are abundant compared with the previous few series a lot.
Datasheet-LM3S9B96
- TI Stellaris LM3S9B96 的 Datasheet，该 MCU 使用 ARM 公司 Cortex-M3 内核，为新的一代 MCU。-TI Stellaris LM3S9B96 the Datasheet, the MCU to use ARM' s Cortex-M3 core, as a new generation MCU.