资源列表
uart_v
- 单片机A/D接电位器，串行口接PC机，单片机每隔1秒将采集的电压经串行口送给PC机。-Single Chip A/D then potentiometers, serial port access PC, SCM will be collected at intervals of 1 second, the voltage through the serial port to give PC.
i2c
- 向24C02写入数据；读出地址由8位拨动开关输入，拨动开关时，读出的数据显示在8个发光管(G6区)上。-Write data to the 24C02 read out the address from the 8-bit DIP switch input, toggle switch, the read out data show that in the eight light-emitting tubes (G6 district) on.
LOGOLAR
- It is not a pencil sharpener. it is a screwdriver but it cannot be a screwdriver. it must be a pencil sharpener
i2c_Source_code_Scenario_Analysis(beta2)
- I2C Source code Scenario Analysis(I2C 情景代码分析)-I2C Source code Scenario Analysis(I2C Source code Scenario Analysis
bjdjkz
- 由单片机P2口输出的脉冲信号来模拟4相线圈产生的电流，来控制步进电机，用4个LED亮灭的快慢来模拟电机的速度，用它们的亮灭顺序来模拟电机的相序和拍数。-P2 port output from the MCU to simulate the four-phase pulse signal generated by the coil current to control the stepper motor, with 4 LED light blinking speed to simulate th
TLC549ADCto89S52andLEDDisplay
- TLC549AD转换,串行输出至AT89S52，经38译码器驱动数码管按位显示0或1数字量-TLC549ADC to 89S52 and LED Display
BNC
- 高频，视频传送接口，有做视频压缩，编码解码的需要，机械安装图纸-BNC sizer
MSP430xldpjsycyycxsj-gp
- MSP430系列单片机实用C语言程序设计-电子书程序-MSP430 cd
binaryclock_16F88
- C51 designed using the binary clock
frequency-counter-pic
- C51 designed using the frequency counter, it will automatically switch range, there are testing the data source
lcd-volt-meter-pic
- pic lcd voltmeter there are testing the data source