资源列表
stratix2_handbook
- 华为PCB设计规范,主要涉及布局,布线,仿真,还有工艺要求-Huawei PCB design specifications, mainly related to the layout, routing, simulation, as well as the technical requirements
keilc51knowledge
- 该书详细介绍了KEIL C51编程的基础知识,对于KEIL C51的入门者来说是一本非常实用的资料-The book details the KEIL C51 basic knowledge of programming for the beginners KEIL C51 is a very useful information
5Vdyb
- 5V电压测量源程序，采用AD0809芯片，液晶显示，有上下限报警-5V source voltage measurement, the AD0809 chips, liquid crystal display, there are upper and lower limits alarm
procedures
- 51单片机的GSM收发短信C程序,包括了字库转换及IIC通信程序-51 single-chip transceiver for GSM SMS C procedures, including the font conversion and IIC Communication Program
PWM
- 基于C8051f330产生的PWM控制直流电机的转速。是初学者编写的程序。-C8051f330 generated by PWM-based DC motor speed control. The procedure is to prepare beginners.
bongying
- 波形发生器，能产生方波、三角波、锯齿波、正弦波、踢波。-Waveform generator, to produce square wave, triangle wave, sawtooth, sine wave,
DS18b20
- 此部分程序运用:实验开发板上的1-WRIE总线方式工作的温度传感器DS18B20； 实现对现场温度的测量 此部分的程序 包括： 1.LCD-1602A的驱动程序 2.DS18B20驱动程序以及在多个DS18B20以1-WRIE总线方式级连时， 对每个DS18B20的序列号的搜索、分辨率的设置等-LCD1602 display temperature and DS18b20
Barriermeasuredanglemeasuringcar
- 测障测角小车，能实现检测障碍，检测角度-Barrier measured angle-measuring car
1602
- 基于51单片机驱动LCD1602液晶显示。-LCD1602 based on 51 single-chip LCD driver.
motor
- 用298n驱动两个直流电机，具有正反转、PWM加减速控制-298n drive with two DC motors with a positive, PWM speed control
DA0832.AD0809
- DA0832和AD0809的程序，教你如何使用AD和DA模数数模世片-AD0809 and DA0832 procedures teach you how to use the AD and DA modules chip digital-to-analog world
StructuralAnalysis
- trussanalysis is done in this work.. for any type of truss u can use this code which was developed in C