资源列表
ex4-4
- 计时器Timer0的溢出中断控制：使用8051的P1连接到一个共阳七段显示器，然后利用计时计器Timer1，让8051在指定的时间间隔内显示出0~9。-Timer0 overflow interrupt timer control: the use of 8051 a total of P1 is connected to a Seven-Segment Display Yang, and then use time keiki Timer1, so that in 8051 within th
ex4-5
- 外部中断INT0，使用AT89S51的P1连接到8颗LED，P1在正常状况下会输出跑马灯，然后通过用户触动外部的硬件来中断INT0，当INT0引脚有低电位的脉冲出现时，8个LED会一闪一灭。-External Interrupt INT0, use AT89S51 of P1 is connected to 8 LED, P1 will be in normal circumstances the output Marquee, and then through the user to touc
menu
- 用lpc2368设计菜单，无操作系统，菜单采用消息机制进行处理，分成三个函数实现-Design lpc2368 menu with no operating system, menu mechanism to deal with the use of information, grouped into three function
OK20070907
- 可测范围:0-125度 DS18B20的信号脚接P1.7 -asm
TCPIP
- 基于51单片机，在此基础上裁剪TCP IP程序-based on 51microcontroller,TCP/IP programm is writeen
628
- 飞思卡尔智能车调试程序，有关舵机和直流电机的PID控制算法-Freescale debugger smart car, the steering gear and the DC motor PID control algorithm
51timer
- 51下定时器做1秒精确延时，可直接用作模块调用-Under 51 to do 1 second precision timer delay can be directly used as a module called
music
- 基于51单片机的音乐例程，单片机C语言轻松入门-51 single-chip-based music routines, single-chip C language easy entry
Demo
- 使用T1作为定时器（定时时间为50毫秒），T0作为计数器（计数由电机测速电路产生的脉冲个数，每转4个脉冲），每1秒时间后，读出T0的值（读出后须将T0清0），将该值（速度值*4）显示到LED数码显示器上-The use of T1 as a timer (time of 50 ms from time to time), T0 as a counter (counting from the electrical pulse generated by gun circuit number, 4 p
sy
- 利用ADC0809和DAC0832实现模拟电压信号的采集与输出。-ADC0809 and DAC0832 to use for analog voltage signal acquisition and output.
Dem
- 学习用定时/计数器产生PWM波。实现对直流电机转速的检测和开环控制-Learning to use timer/counter PWM wave generated. DC motor speed to achieve the detection and open-loop control
USART_128L_090611
- atmega128L 两个USART：USART0和USART1的应用程序，多机通信模式暂缺-atmega128L USART0 and USART1 Multi-devices communication mode is needed