资源列表
C19_uCOS-II_SCIShineLED
- 本程序实现的硬件平台为苏州大学MCU&DSP研发中心的MC9S12DG128核心板与MT-ExBorard-Ⅰ型扩展板。该硬件平台使用9.8304MHZ的有源晶振，配置后系统程序运行的总线频率为4.9152MHZ。硬件连线方面，使用扩展板下方的10到17脚即标识为LED1_LD0至LED1_LD7的引脚连接8盏小灯；板上SCI1连接PC的串口，通信波特率为9600。 在这个实例中，我们利用PC机串口发送的一个字节数据来控制八盏小灯的闪烁。 -This procedure for the
C05_LCD
- C05_LCD，LCD的DB0-7,RS,R/W,E与MCU的普通I/O口引脚连接，MCU的串口与PC方的串口相连，MCU接收PC发来的32个字符,并送LCD显示-C05_LCD, LCD the DB0-7, RS, R/W, E and MCU general I/O port pin connection, MCU and the serial port connected to PC' s serial port, MCU sent PC to receive the 32 cha
waveform_generator_design
- 基于单片机的结晶器液压振动波形发生器的设计—上位机部分-The crystallization of single-chip microcomputer-based hydraulic vibration waveform generator design- part of host computer
AVRmonitaor
- 本文档用于描述一体化组合模块485监控板监控对象，以及单片机实现功能的简单概述。-This document is used to describe the integration of portfolio monitoring board monitoring module 485, as well as the function of single-chip realization of a simple overview.
max232
- max232与上位机通信程序，带有数码管显示-max232 with the host computer communication program, with digital display
serialforavr
- 主要是配合avr单片机的一个测试程序,里面有串口通讯,和listiew潜入控件-Mainly avr microcontroller with a test procedure, there are serial communications, and control into listiew
traffic
- 交通灯演示c程序，采用定时器实现计时，与交通灯演示delphi程序配套-C procedures for demonstration of traffic lights, using timers to achieve time, with traffic lights delphi demo program package
key
- 键盘扫描完整c程序，并带有数码管显示，可以实现加一，减一，复位等功能。-C program to scan the full keyboard and a digital display, plus one can be achieved, by a reset functions.
MMC
- uc/FS 1.34版本 MMC/SD卡驱动-MMC/SD card driver for uc/FS 1.34
msp430f449
- msp430f449蓝色版输出灯颜色变化定时器TA程序-msp430f449 version of the output light blue color change process timer TA
msp430f449-1
- msp430f449蓝色版-----发光二极管闪烁------ Version msp430f449 blue flashing light-emitting diodes
msp430f449-2
- msp430f449蓝色版开发编程语言--发光二极管闪烁-msp430f449 blue version of the development of programming languages- blinking LED