资源列表
zidongjialiaojixitong
- 本设计的由单片机控制的自动加料系统是与料斗式干燥机配套的加料系统。根据加料工艺要求，其工作原理是：先将真空管关闭，启动电机，用低真空气流将塑料树脂粒子送入真空管，电机停转，再将粒子排入料斗，如此循环。-The design of single-chip microcomputer controlled by the automatic feeding system with hopper dryer feed supporting system. Charging process in acco
thermometer
- 语音温度计输出当前摄氏度，如果超出一定的范围会报警。-Degrees Celsius thermometer voice output current, if the scope will go beyond a certain alarm.
LED
- 我写的四字点阵，1664的。用字库显示。有1302的时间显示。C语言，有proteus的仿真-I wrote the word dot-matrix, in 1664. With font display. 1302 shows that there is time. C language, proteus simulation
74HC164N
- 本程序可以利用74164串入并出芯片在七段共阴数码管上依次点亮0至9十个数字.. PA0....数据 PA1.....CP PA2.....是位选 在ATMEGA644P上调试通过-This procedure can be used to string 74,164 and a total of a chip in the seventh followed by vaginal digital tube light figures 0-9 10 .. PA0 .... d
MSP430TimeA
- 用MSP430F449 定时器A模拟的串口代码，C语言，已经测试通过-MSP430F449 timer A simulation using the serial code, C language, has been tested
DS18B20
- 它是关于单片机与温度芯片DS18B20的资料，通过单片机采集芯片DS18B20温度-It is a single-chip microcomputer with on-chip temperature DS18B20 information collected through the single-chip-chip temperature DS18B20
Touchscreencalibrationmethod
- 主要用于去触摸屏坐标的校验。对屏坐标的检测-Touch screen is mainly used to check the coordinates. Coordinates on the screen test
INT_CALC
- 针对51单片机的中断触发按键的程序，利用P3.2口接行列按键。-For 51 single-chip key interrupt to trigger the process, I then use the ranks of P3.2 button.
ADC0809
- ADC0809数据采集系统 ADC0809数据采集系统-ADC0809
CC2430-1
- CC2430 基础实验一LED灯自动闪烁-CC2430 experimental basis for a flashing LED light automatically
CC2430-2
- CC2430 基础实验二 按键控制开关实验-CC2430 experimental basis experiment 2 button control switch
CC2430-3
- CC2430 基础实验三 按键控制LED闪烁-CC2430 three buttons to control the basis of experimental LED flashes