资源列表
ATmega16-nrf24l01
- ATMEGA16 AVR单片机测试NRF24LO1模块（基于硬件SPI）CVAVR编译-ATMEGA16 AVR microcontroller test NRF24LO1 module (hardware-based SPI) CVAVR compiled
PT2240rx1
- PT2240 receiver for AVR
test_idg300
- Arduino测试idg300，读取idg300的陀螺仪信号，并且通过串口监视器显示出来。要求将传感器的输入端连接到单片机的2号模拟输入端。-Arduino—test-idg300
51code
- 51方面的一些代码-51 some of the code
test
- 人脸智能识别系统下位机程序--使用AT89C52单片机 -Intelligent Face Recognition System-bit machine under the program- the use of single-chip microcomputer AT89C52
MSP430comTONGXIN
- MSP430单片机串口通信原代码C++，开发环境IAR430软件-MSP430 microcontroller serial communication of the original code C++, software development environment IAR430
danpianji100shili
- 单片机学习100实例，函数的使用和熟悉，实例3：用单片机控制第一个灯亮 实例4：用单片机控制一个灯闪烁：认识单片机的工作频率-100 instances of single-chip learning, a function of use and familiarity, Example 3: The single-chip control of the first instance of four lights: flashing lights with a single-chip co
ProtelDXP
- 里面有150个常见的用protel DXP做的PCB图，是学习画电路图的非常好的东东，推荐给大家。-Inside there are 150 common to do with protel DXP PCB diagram, schematic drawing of learning very good stuff, recommend it to everyone.
ILI9325C
- ILI9325C的2.8寸TFT驱动程序，16位数据总线，采用单片机P0与P1口驱动，间接驱动方式。-2.8-inch TFT ILI9325C driver, 16-bit data bus, the use of single chip port P0 and P1 drivers, indirect drive.
stm32-motor_control-code
- STM32控制步进电机的程序，2011全国大学生电子设计竞赛用的，调试通过的，可以直接拿来用-STM32 stepper motor control program, 2011 National Undergraduate Electronic Design Contest used, debugging, and can be directly used
CANBus
- 详细介绍CAN总线的原理以及在汽车方面的应用-Detailedly introduce the principle of CAN bus and its application on automobiles.
tlc1549
- 程序参考---TLC1549数据采集 单片机：At89S52 连接类型：232 |485 接口 校验方式：checksum 开发环境：keil C-Procedures refer to single-chip--- TLC1549 Data Acquisition: At89S52 connection type: 232 | 485 calibration methods: checksum development environmen