资源列表
CH375-SLAVE
- USB 1.1 Slaver for CH375:CH375做slaver的程序,单片机用89C2051.与我之前上传的CH375-HOST对应,联系起来使用. -USB 1.1 Slaver for CH375 : CH375 do slaver procedures, Microcontroller with 89 C2051. Before I uploaded CH375 - HOST counterpart and linked use.
I2C_24c02
- i2c总线对于单片机的扩展,本人调试过，可以采用高速模式即400k的速度传送。-i2c Bus for the expansion of SCM, I debugging that use the high-speed mode is 400 k speed transmission.
I2C_ASM2
- 此是本人调试成功的用ASm汇编写的 IIC EEPROM 的程序，不会的可以借鉴一下。-this is my debugging ASm success of the compilation was made by the IIC EEPROM process, No can learn from this.
RP89com3
- 采用P89CXX编程器控制CPU接收和控制程序，简单实用。-P89CXX programming device used to control the CPU to receive and control procedures, simple and practical.
reset0703
- 你知道如何让单片机进入低功耗状态吗，进去看看吧！-let you know how to enter the low-power MCU state yet, go in and have a look!
soft_ad0703
- 软件A/D所能实现的精度有限，测量电压范围是2-15V， 而且速度低(约1KHz),但仅用一个电容和一个电阻的诱惑 力，我想大虾您会笑纳的。用于某些场合是有用的。-Software A / D can achieve the accuracy is limited, measuring voltage range is 2-15V, and low-speed (approximately 1 KHz), but only a capacitance and resistance of
at29c040_Card0703
- 用单片机检测电子卡的小程序，包括检测信号处理信号。-MCU detection of small electronic card procedures, including the detection signal processing signals.
DS12C887-LCD
- 利用DS12C887时钟芯片实现时钟的LCD显示-use DS12C887 clock chip clock LCD Display
yjkfrj
- 清华蓬远的液晶字库显示程序用于单片机的液晶图像的显示傅睿淼上传-far LCD character display program for SCM LCD image display FU Rui Miao Upload
mp3_atmel
- atmel单片机开发的mp3,里面有原理图及源代码.-atmel microcontroller development of the mp3, with a diagram and the source code.
myds18b20
- 本人自己的项目，用单片机控制DS18B20,并且在LCD(161)上进行显示，显示精度为小数点后四位，绝对能用，正在使用中-my own projects, using SCM control DS18B20. and the LCD (161) on the show, showing accuracy of four decimal places is absolutely can use, is to use!
my_music
- 自己的项目，用单片机控制喇叭发出音乐，可以奏出5首歌曲，绝对可用-their own projects, using SCM control tune music, can play five songs, absolutely available!