资源列表
ADC0832应用
- 基于AT89C51，采用LCD1602液晶显示0~5V模拟电压量。采用proteus仿真和KEIL4 C语言编程实现。(Based on AT89C51, the LCD1602 liquid crystal display 0~5V is used to simulate the voltage quantity. It is realized by Proteus simulation and KEIL4 C language programming.)
wenShiDu
- 用于GEC210板子的DTH11温湿度传感器驱动(DTH11 temperature and humidity sensor driver for GEC210 board)
P1_PLUS_V2.0
- stm8L052应用例程，驱动12864液晶及LED显示，是初学者很好的参考资料。(Stm8L052 application routine, driving 12864 LCD and LED display, is a good reference for beginners.)
MSP430F5529-UART-RTC
- RTC+UART,可以通过串口发命令控制是否发送时间以及发送的间隔时间(RTC,UARTC,commands can be sent through the serial port to control whether to send the time and send the interval)
src
- MSP430实现RS485通信，LCD显示，已经相关业务实现。(MSP430 implementation of RS485 communication)
adc2
- stm32 adc 测试，自己测试能用。非常实用（标准库）(Stm32 adc test, own test can be used. Very practical (standard library))
led测试程序（调试通过）
- led测试程序，led灯基础点亮！stm32(LED test program, LED light foundation lighting! Stm32)
CAN-1
- 基于STM32F4例程,CAN总线的编程方式，开发语言是C语言.........(Based on the STM32F4 routine, the programming mode of the CAN bus, the development language is the C language.)
AD7606_103ZE_FSMC__DMA_USB_FIFO_8CH_200KHz
- 通过stm32f103z，控制AD7606实现数据采集，将采集到的数据通过芯片FT2232，以USB总线快速传输，共8个通道，可同时达到16位，200k的采样率。(Through stm32f103z, AD7606 is controlled to realize data acquisition, and the collected data is transmitted quickly through chip FT2232 to USB bus. There are 8 channels
1、烧写工具
- 烧录固件 ESP8266(Burning firmware windows64/32)
RX
- stm8s003f3p6 NRF24L01接收程序 已调通(Stm8s003f3p6 NRF24L01 receiving program has been tuned)
TX
- stm8s003f3p6 nrf24l01发送程序 已调通(The stm8s003f3p6 nRF24L01 sending program has been tuned)