资源列表
9、CC2530 串口UART0发送字符串
- cc2530 uart模式 串口发送数据给cc2530 ，发送一次led闪烁一次(cc2530 uart send char.The led light when cc2530 received data from uart.)
6. SC-printf
- 单片机串口通讯协议的实现，使用printf输出到电脑(The realization of the serial communication protocol of single chip microcomputer, using printf to output to the computer)
8. LCD1602-移入显示
- 液晶的移入显示实现，利用Proteus仿真，Keil编程。(The liquid crystal is moved into the display, using Proteus simulation and Keil programming.)
MyScomTest可实时显示数据
- 基于Matlab的串口实时接收数据。并显示(The data is received in real time based on the serial port of Matlab. And display)
W25Q256四字节读写程序
- W25Q256四字节读写程序实例，非常实用(W25Q256 four byte read and write program instance)
sensor_LIS3DH_driver
- 加速度传感器 LIS3DH 的驱动参考代码(acceleration sensor LIS3DH driver code)
实验1 跑马灯实验
- led的切换功能,stm32最简单的实验(The handoff function of LED, the simplest experiment of stm32)
tm1617
- TM1617驱动程序，内部包含按键处理以及显示驱动软件(TM1617 driver, which contains key processing and display driver software)
24L01drive
- 2401无线通信模块驱动程序，分为主机接收和从机接收两大模块，亲测好用(2401 wireless communication module driver, divided into the host receiving and receiving two modules from the slave machine.)
STC89C52_hx711_AD
- 使用hx_711AD转换模块对一段未通电的无漆包或者绝缘外皮的导线长度的测量，程序精度在3mm内会有小部分误差。(The hx_711AD conversion module is used to measure the length of an uncharged unpainted or insulated sheath, and the accuracy of the program will have a small part of error in the 3mm.)
24C08 模块 YL-90 资料
- AT24C08模块资料，还是比较详细的。(AT24C08 module data, were detailed.)
Unit8
- 定时开始工作红指示灯亮，结束时绿指示灯亮(Timing start work the red indicator, at the end of the green light is lit)