资源列表
LTC6803-G128_14
- 电池管理程序，单电压采样，均衡，温度采样，LTC6803的使用，是学习电源管理的好参考程序。-Battery Management
ATmega8_USART_FRAME
- 串口帧发送接收测试程序，采用ATmega88单片机，时钟16MHz，ICCAVR工程。-A source code demonstrates sending/receiving serial frame. MCU is ATmega88, clock frequency is 16 MHz， built by ICCAVR.
1302
- 单片机万年历设计，把从ds1302读取的数据显示在lcd1602.并且可以对时间进行设置-SCM calendar design, the data read the ds1302 displayed in lcd1602. And can be set for time
PWM
- 利用MSP430F149控制输出PWM波来调节LED灯的亮度-Use MSP430F149 control output PWM wave to adjust the brightness of LED lights
CHERAQ
- This is a bascom code for led blinker project with atmega8 witch uses PWM tecnicues to do this
mainSend
- 1、Cmos Sensor OS 测试； 2、主控单片机型号：STC15F4K60S4 3、模拟电子开关：CD4051 CD4067BM96 4、单片机控制模拟电子开关自动采集被测Sensor 各PIN的导通压降，将数据通过串口 发送至上位机，上位机接收数据并对数据进行分析判断，给出最终的OS测试结果； 5、单片机10位精度AD 电压采集； 6、支持单片机串口通信；-1, Cmos Sensor OS test 2, the master SCM model: STC1
MyProject
- pic16f1527芯片的串口usart通信-uart chip serial communication pic16f1527
STM32-UART
- STM32F103 uart 串口通信程序 基于MDK平台完整工程-STM32F103 uart MDK
STM32-IIC
- STM32 IIC 源码完整工程 基于MDK开发环境-STM32 IIC MDK
stm32f407Project
- 基于stm32f407的can总线多机通信程序，包含从机的编码设置，以及从机的信息接受等-Based on the can bus stm32f407 multi-machine communication procedures, including machines encoding settings, and the information receiving and other machines
ESP8266
- ESP8266模块最经典例程 非常好的哦-ESP8266 module classic routines very good oh
usart
- stm32f103的多串口（串口1到串口4）间的数据处理、转发-stm32f103 multiple serial port (port 1 to port 4) Data processing between forwarding