资源列表
PWM_test
- PWM的使用和编程方法，初始化PWM模块，并实现输出波形占空比的增大和减小。IPLL模块的使用，将总线时钟设定为40MHz。编程环境:Freescale CodeWarrior 5.1.-The use and programming of the PWM method, the PWM module is initialized, and to achieve that the output waveform of the duty cycle to increase and decrease
CE337-I2C-Master
- CE337 I2C Master for microchip
CE338-I2C-Slave
- CE338 I2C Slave for microchip
Bootloader
- USB BootLoader for MCF51JM128
pid
- 在使用单片机作为控制cpu时，请稍作简化，具体的PID参数必须由具体对象通过实验确定-Microcontroller as control cpu, some simplification, the PID parameters must be experimentally determined by the specific object
TM1812
- tm1812原控制程序，很好的LED控制参考材料 -tm1812 original control program, a good LED control reference material
tm1803led
- tm1803芯片控制程序，很好的led控制资料-the tm1803-chip control procedures, good led control information
01
- 8*8*8光立方驱动。74hc573+uln2803.-8* 8* 8 cubic optical drive. 74hc573+uln2803.
3d8
- 光立方 3D8 程序。驱动。底层驱动。8*8*8光立方。AVR单片机。-Optical cubic 3D8 program. Drive. The underlying driver.
4x4x4code
- 4*4*4光立方驱动。单色光立方，使用单片机直接PWM方式直接驱动。P1P2口接16个二极管，P3接四层-4* 4* 4 light cube driver. Monochromatic cubic microcontroller direct PWM drive directly. P1P2 mouth 16 diodes, P3 then four
888
- 8*8*8 自作过程，LED管的弯折，组装，焊接过程。单片机驱动程序等。自行DIY手册。-8* 8* 8 since for the process, LED tube bending, assembly and welding process. MCU driver. Own DIY manual.
3D81
- 3D8原创程序。使用单片机驱动，底层代码。多动画，完整的注释批注。8*8*8光立方。控制512个发光二极管-3D8 original program. The use of single-chip driver, the underlying code. Multi-animation, complete notes annotations. 8* 8* 8 Light Cube. Control 512 light-emitting diode