资源列表
01uart_test
- 51单片机简单串口通信的程序，不断发送“I get”，受到数据后led翻转。-51 SCM simple serial communication procedures, continues to send " I get" , by the data led flip.
PWM
- TI的MSP430G2553的PWM程序。希望和大家一起分享，也给我提出一点改进的建议。谢谢。-TI s MSP430G2553 PWM program. Hope and share with everyone, also give me a little put forward Suggestions for improvement. thank you
no1.LED_SHOW_CODE_AVR
- 本程序是AVR单片机：http://www.ipbb.cn/post/avr.html的LED灯闪烁的C语言程序，这个是每个初学者必须经历的实验噢！-This procedure is the AVR MCU: C language program http://www.ipbb.cn/post/avr.html the LED flashes, this is every beginner must go through experiment
no7.Key_jiajian_SMG_SHOW_CODE
- AVR单片机的按键控制数码管的加减显示，单片机教程：http://www.mcujc.com初学者的朋友们需要注意，数码管有共阳共阴之分的，必须注意啊！-AVR Microcontroller keys addition and subtraction to control digital tube display microcontroller tutorial: http://www.mcujc.com beginner friends need to pay attention, the
no8.INT0_jishuo_SHOW_code
- 基于AVR单片机的INT0中断计数C语言程序，单片机教程：http://www.mcujc.com，外部中断触发一次，然后就会加1显示。对AVR单片机不熟悉的朋友们可以参考一下！-Based on AVR Microcontroller INT0 interrupt count C language programming, microcontroller tutorial: http://www.mcujc.com external interrupt trigger time, then i
c8051f_usb_bootloader
- c8051F usb bootloader hid-c8051F usb bootloader hid
an44168_13
- host sourced serial programming
msp430f149-for-PWM
- msp430f149单片机产生pwm波控制2个电机转动的C程序-msp430f149 microcontroller generate pwm wave C program to control two motors rotating
CMAXQUSB_U1_S0104
- The Maxim Command Module (CMAXQUSB) receives commands from an IBM PC through USB to create
MSP430F149-TimerA-pwm
- MSP430F149 TimerA 输出pwm信号-The MSP430F149 TimerA output pwm signal
MSP430-classical-program
- MSP430的一些经典例程讲解，希望对大家对MSP430开发有些帮助-MSP430 classic routines to explain
MSP430G2553-PWM-square-
- MSP430G2553产生在一定范围内任意占空比,任意频率的方波-MSP430G2553 produce within a certain range arbitrary duty cycle, square wave of any frequency