资源列表
liushuideng
- 单片机protues软件单片机仿真程序流水灯-The the microcontroller protues software microcontroller simulation program of light water
AD_LED
- 利用avrm8作控制器，winavr，C语言环境，将avrAD采样数据处理并通过串口转发上位机，配上位机软件-Use as the controller winavr C language environment avrm8, will avrAD sampling data processing and forwarding the host computer through the serial port, coupled with computer software
stm32lcd
- 刷屏显示实验 金牛实验板的刷屏显示 金牛实验板的刷屏显示实验-Refresh to display the experimental the Taurus experimental board scraper scraper showed that the experimental the Taurus experimental board
stm32-CAN
- CAN实验，这是金牛开发板的CAN实验这是金牛开发板的CAN实验-CAN experiment, this is a Taurus development board CAN experiment, this is a Taurus development board CAN experiment
stm32-OV7670
- 摄像头实验，这是金牛开发板的摄像头实验这是金牛开发板的摄像头实验-Camera experiments, this is a Taurus development board camera experiment, this is a Taurus development board camera experiment
chuankoushujucaiji
- 通过串口实时采集数据，并将它们绘制成图形。-Real-time data acquisition via the serial port, and graphed.
A1
- IAR环境下 MSP430-149F，以参考电压为采样信号的ADC采样示例程序，当采样到的电压A0>0.5*AVcc，P3.4（LED）置位，否则复位。- MSP-FET430P140 Demo- ADC12, Sample A0, Set P3.4 if A0 > 0.5*AVcc Descr iption: A single sample is made on A0 with reference to AVcc. Software sets ADC10SC to
A2
- IAR环境下的MSP430F149,使用内部参考电压为采样信号的单路AD转换的采样程序。- MSP-FET430P140 Demo- ADC12, Using the Internal Reference Descr iption: This example shows how to use the internal reference of the ADC12. It uses the internal 2.5V reference and performs a single
Main
- MT8888发送数据部分程序，程序用来将数据进行DTMF编码，然后发送出去-MT8888 to send data part of the program, the program used the data for DTMF encoding, and then sent
T1
- IAR环境下的MSP430F149，使用定时器A，每隔5000个时钟周期点亮/熄灭LED的程序- Descr iption: Toggle P3.4 using software and TA_0 ISR. Toggles every 50000 SMCLK cycles. SMCLK provides clock source for TACLK. // During the TA_0 ISR, P3.4 is toggled and 50000 clock cycles ar
Received_check
- MT8888数据接收程序，将接受到的双音信号解码。-MT8888 data reception program, will receive the two-tone signal decoding.
daima
- 51单片机驱动16x16液晶显示器，含C文件，proteus文件和hex文件-51 single-chip driver 16x16 LCD display, containing C file, proteus file and the hex file