资源列表
Matrix_max7219_51
- STC89C51使用Max7219驱动8x8阵列。和arduino实验一样，也带proteus仿真，本人亲手制作。-STC89C51 using Max7219 drive 8x8 array. And arduino experiments, as also with proteus simulation, produced by my own hand.
8051
- 《单片机C语言程序设计实训100例——基于8051与Proteus仿真》.rar-" Microcontroller C Programming Language Training 100 cases- 8051 and Proteus based simulation" . Rar
msp430
- MSP430 learning source code
I2CEE-Schematic
- i2c eeprom interface for avr
Keypad
- Keypad Demo FOR AVR Micro ic C language (CodeVision)
CarControl
- 小车控制程序需要烧进小车的代码以及控制指令示例。该小车采用的是单片机后轮驱动。-Control procedures need to burn the car into the car and the control commands the code example. The microcontroller is used in car rear-wheel drive.
12_28_1549
- 另一个版本的小车控制程序，小车控制的指令不一样，可以控制车速，左转、右转、前进、后退、停止等-Another version of the car control procedures, control commands not the same car, you can control the speed, turn left, turn right, forward, backward, stop, etc.
USB_IrDA_Bridge_Device_Definition
- USB SPEC（USB implment forum官方文档） - USB 红外线桥设备定义-USB IrDA Bridge Device Definition
SystemCBasic2010
- SystemC basic introduction for beginners
systemc_1_tutorial
- SystemC tutorial for beginners
yy
- 高速ADC前端设计的集锦 有十分重要的参考价值-Collection of high-speed ADC front-end design has a very important reference value
weiji
- 声-光报警程序 运行步骤:1.按下一次开关SW3,开始声-光报警,再按下一次则停止 重复上述操作* 2.按下"q"或者"Q",退出 -Sound- light alarm program* run these steps: 1. Press a switch SW3, began to sound- and light alarm, and then press again to stop Repeat* 2. Press the " q" or &