资源列表
17c42
- PIC子程序，用于方便查找简单的子程序，不用浪费多余的时间-PIC subroutines
keyboard
- 基于stc51单片机开发试验板的第二份键盘程序。c代码-Based on the microcontroller development board test stc51 keyboard program. c code
d
- main函数中两个参数的用法 MSDN6.0中写道:argc is An integer specifying how many arguments are passed to the program from the command line. Because the program name is considered an argument, argc is at least 1.-main function uses two parameters MSDN6.0 wrote: arg
main
- 单片机P0.16低电平触发外部中断0通过按键控制-Microcontroller P0.16 low level triggered external interrupt 0 through key control
RUN-LED
- LED跑马灯，循环控制，不断显示，在飞思卡尔下-run LED,it runs all time in the type of control by the chipper of freescale
stopwatch
- 数码秒表设计:开发板上4键从左至右为S1-S4，上电后，开始时显示 0.0 ； 利用S1按键后启动计时；S2按键后停止计时；S3按键后计时归零；最大计时 为9.9秒。计时误差小于0.2秒，显示稳定。 晶振频率：11.0592MHz -Digital stopwatch design: 4 key development board left to right S1-S4, after power is displayed at the beginning of 0.0 S
8bit
- 基于51单片机的lcd 8位数据位控制代码-Based on 51 MCU LCD 8 bits of data control code
AD
- 串行ADTLV2543和DATLV5618的接口程序
4004
- 语音芯片isd4004的驱动程序，具有录放功能
res
- 基于PCA的定时模块，便于大家快速使用单片机的第三个定时器PCA模块，stc12ca60s2-PCA-based timing module for you quick access to the third timer chip PCA module, stc12ca60s2
18b20P0
- 当使用大量18b20的时候，这个程序就很有用，本程序可以读写在c51P0口上p0.0-p0.7的所有传感器。使用者稍加修改就可以读取P0-P2口上的所有传感器。-When using a large number 18b20, this procedure can be useful, the program can read and write in the mouth c51P0 on p0.0-p0.7 all the sensors. Users can read a little mo
CRC
- CRC 程序，可用于modbus通讯等子程序的调用。-CRC program can be used for modbus communications subroutine calls.