资源列表
KEY-CONTROL-PWM-LED
- c语言开发单片机 控制跑马灯的亮度的变化 按键控制亮度增减-C develop SCM Control the brightness of the scrolling the change of control buttons increase or decrease brightness
disp
- 用数码管前两位显示一个十进制数，变化范围为00~59，开始时显示00，每按下S2键一次，数值加1；每按下S3键一次，数值减1；每按下S4键一次，数值归零；按下S5键一次，利用定时器功能使数值开始自动每秒加1，再次按下S5键，数值停止加1，保持显示原数。-Digital tube first two shows a decimal number, range 00 to 59, the beginning of display 00, press S2 button once, increment
yejingzongxian
- 液晶动态显示程序和单片机利用总线进行传输数据的代码-LCD display dynamic program and single-chip bus transfer data code
PIC16F1936qudong5110LCD
- PIC16F1936驱动5110LCD液晶程序 ，C程序，MPLAB开发环境-PIC16F1936 drive 5110 LCD procedures, C program, MPLAB development environment
ad_0834-ds18b20
- 压缩包里有我们非常常用的子程序，包括DB18B20，ad_0834，在单片机开发中可以直接调用，也有比较好的注释，对于新手是不错的选择-Compression bag has us very common subroutines, including DB18B20, ad_0834, in microcontroller development can be called directly, but also a better note, is a good choice for the no
led
- 用单片机来实现led灯的动态显示，节约材料的条件下，来达到各种要求-MCU led lights to achieve dynamic display, saving material under conditions, to achieve the various requirements
Poweron_initial
- 开机后的启动流程at89x51初始化及相关编程-boot after the start at89x51 initialization process and related programming
spi595
- 介绍了用74HC595驱动LED显示的程序，用汇编编的-introduces the Bit LED Display Driver procedures used in the compilation series
time
- 此程序为4个8段数码管计时程序，简练、易动
chang_x5045
- 51单片机5045看门狗芯片的代码（通过编程）
good-for-weifu
- 单片机伟福版，六位数码管动态显示，电子时钟进位显示时分秒-SCM weifu version, six digital tube dynamic display, electronic clock shows the carry minutes
PWMLED
- 利用定时器控制产生占空比可变的 PWM 波 按K1，PWM值增加，则占空比减小,LED 灯渐暗。 按K2，PWM值减小，则占空比增加,LED 灯渐亮。 当PWM值增加到最大值或减小到最小值时，蜂鸣器将报警。-Have a timer to control the use of variable duty cycle PWM wave by K1, PWM values increase, then decrease the duty cycle, LED lights dimming