资源列表
COS-II_Fujitsu-MCUf2mc
- 富士通单片机移植μCOS-II，代码很全，可直接应用-Fujitsu MCU transplant μCOS-II, the code is very wide and can be applied directly
Cognitive_radio.pdf
- Introduction to cognitive radio, describes basic understanding on the system.
SED1335
- SED1335液晶屏的程序 参考别人的程序 并自己增加了一些有用的绘图函数 程序已经通过实际测试
LX-D01_bin
- LX-D01倒车雷达主机程序BIN文件、ASM文件-LX-D01 car rare radar, the host program the BIN file, ASM files
SPI_TEST
- LPC1768SPI主从通信，开发环境KEIL4，数据通信正常，主机发送，送机接受然后写一个数据，主机读数据，采用中断读-LPC1768SPI master-slave communication, KEIL4 development environment, the data communication, the host sends, to accept and then write a data, the host read data, using interrupt read
TouchKey
- 单片机,在HOLTEK芯片上开发触摸键盘代码-8BIT HOLTEK SOC TOUCHKEY CODE
ICCAVR-Program
- IRQ Pin Drive Strength. Setting this bit configures the IRQ pin as an open drain output. Clearing this bit configures the IRQ pin as a standard CMOS output, with the output “1” drive voltage being equal to the VIO pin voltage. Bit 6 IRQ Polar
fupintexing
- 利用FPGA和MSP430单片机幅频特性和相频特性的测试。-FPGA and MSP430 microcontroller amplitude-frequency characteristic and phase-frequency characteristics of the test.
Pluser
- 自己做的一个简单的设备.使用Freescale HC908SR12单片机,使用KEYS,AD,PWM,FLASH,LCD等模块.经使用运行稳定.-do for myself a simple equipment. HC908SR12 use Freescale MCU, use KEYS, AD, PWM, Flash, LCD modules. by the use of operational stability.
20080421-18b20-tempercontrol
- 1820显示温度（LED(595)）C语言版 通过串口设定温度和读取当前温度
Multi-function-alarm-clock
- 实现多功能闹钟：通过语音芯片的录放音来实现闹铃功能，同时通过时钟芯片实现定时功能，通过矩阵键盘实现调时功能。-Multi function alarm: through the voice chip recording to achieve the alarm function, at the same time through the clock chip to achieve the timing function, through the keyboard matrix to achiev
UART
- LPC1768 串口程序，已调试通过，供开发者、初学者参考-LPC1768 UART DEMO