资源列表
ProtelPCB2SCH
- protel 从pcb转化为sch原理图。-protel sch from the pcb into the schematic.
uart
- AVR单片机串口通信程序的设计范例。是初学者开发者好的参考资料。-AVR microcontroller serial communication program design examples. Is a good reference for beginner developers.
CK0726V24
- 1，Ni-MH 电池充电器 2，MCU为EM78P258 3，可同时充电节电池或4节电池 4，可充AA电池或AAA电池 5，截止条件为-dV、最高电压、最长时间 6，采用CC+CV+涓流模式充电 -Ni-MH battery charger, MCU for EM78P258 3 rechargeable batteries or four batteries, rechargeable AA batteries or AAA battery 5, the cut-off
252
- 基于uCOS-II的串口驱动(用Keil C)
CC1110_CSMA
- 附件内文件功能是利用TI公司的CC1110单片机实现点对多点载波监听CSMA。程序在IAR7.2软件平台下编译通过，可以在CC1110单片机中正常下载运行。-Within the file attachment feature is the use of TI s CC1110 MCU-to-multipoint Carrier Sense CSMA. Under the program compiled by IAR7.2 software platform, you can download
VECTOR-0.0.1
- AD9958PCB 已经通过调试，可以直接产生多种波型。-Debug AD9958PCB has passed, you can directly produce a wide range of wave-type.
lm3s1138SSI
- 这是我买的开发板中的配套程序，包括1位数码管的静态扫描和8位的动态扫描及SSI的相关介绍，程序我以测试过。-This is a development board I bought the matching procedures, including a digital control of static scanning and 8-bit dynamic scanning and SSI related to introduction, the program I tested.
examples-of-51MCU
- 51单片机的100个开发实例，有源代码，注释很详细哦！-51 SCM 100 development examples, source code, very detailed notes, oh!
C8051-GSM
- 采用C8051单片机控制西门子TC35I GSM模块收发短信，拨打电话的源程序-C8051 MCU control Siemens TC35I GSM module send and receive SMS, call the source
LM35
- 基于LM35温度传感器的温控系统设计,硬件加软件设计，看看有用没有啊-LM35 temperature sensor based on temperature control system design
PCB_Impedance
- cal. impedance for PCB (test)