资源列表
dc_shunt.emt
- In this simulation i simulate the dc machine
综合设计项目一：十字交通灯
- 十字交通灯 用于模拟交通灯 proteus可以仿真(Cross traffic lights are used to simulate traffic lights)
mcu1
- 本文详细介绍了基于单片机和PC机的低频信号采集系统-it has demostrated the MCU and PC in use of LP!
CSDN--LCD12864
- 单片机的部分芯片的补充说明及相关的应用说明，还有要注意的一些问题-Part of the chip microcontroller supplement and related application notes, also pay attention to some of the problems
digitalclock
- 数字电子钟，24时制计时，带有调时功能，对分秒时分别进行调整。-Digital electronic clock, 24 when the system time with when the transfer function, minutes and seconds, respectively to adjust.
PIC-Power-Supply-www.circuitdiagram.net
- power supply pic microcontrollers
msp430-csb
- 使用MSP430F5438单片机和HC-SR04超声波模块实现测距的源码。- Using the MSP430F5438 microcontroller and HC-SR04 ultrasonic ranging module source.
Refined_Code
- 利用飞思卡尔单片机，结合摄像头进行采样，完成在黑边框白线赛道中小车自动行走的程序和算法-Use freescale microprocessor, combining camera for the programme of a car to detect the road
JCR43QD
- jcr43qd 4.3寸彩色LCD的avr atmega128驱动用于显示热量测量重要参数-jcr43qd 4.3-inch color LCD controled by avr atmega128 for displaying important parameters in the calorie measurement
ac
- 工程师应掌握的20个模拟电路Engineers should have 20 analog circuits-Engineers should have 20 analog Engineers should have 20 analog circuits
HT49-MCU-Timer-design
- HT49 MCU Timer design初始值設定並有範例程式列出以供參考-HT49 MCU Timer design to set the initial value and a sample program listed for your reference
example1_TIM
- 本例展示了如何利用外设TIM2来产生四路频率不同的信号。 TIM2时钟设置为36MHz，预分频设置为2，使用输出比较-翻转模式（Output Compare Toggle Mode）。 TIM2计数器时钟可表达为：TIM2 counter clock = TIMxCLK / (Prescaler +1) = 12 MHz 设置TIM2_CCR1寄存器值为32768，则CC1更新频率为TIM2计数器时钟频率除以CCR1寄存器值，为366.2 Hz。因此，TIM2通道1