资源列表
danpianji
- 简单单片机实验程序,实验一、查表程序与子程序 实验二、数据查找与数据排序 -Simple single-chip experimental procedure In Experiment 1, table look-up program and subroutine in experiment two, data searching and sorting data and so on
PIDSimulink
- This chapter describes the PID control s basic concept, introduced the PID control algorithm and PID parameter tuning knowledge, and through a large number of simulation results about the PID parameter tuning
GY-61-ADXL335
- GY-61 ADXL335 的程序代码，需要的可下一下-The source code of GY-61 ADXL335
ILI9325
- 基于stm32的2.8 LCD 液晶屏控制程序，文件完整，修改相应的GPIO参数即可移植。-Based stm32 the 2.8 ' LCD LCD screen control procedures, file integrity, modify the corresponding GPIO parameters can transplant.
Four-aircraft-program
- 基于STM32的四轴飞行器程序使用nrf24l01数传模块-Use nrf24l01 data transmission module based on the STM32 Four aircraft program
yuyinshibie
- 凌阳单片机语音识别范例，有详细的介绍这么改，需要语音识别的地方改改就能用哦-Sunplus example single-chip speech recognition, there are so many changes in detail, where the need for speech recognition can be used to change ... oh ...
eZ430-RF2500
- 本程序是TI研讨会赠送ez430-2500无线通信模块板，测试程序。很有用还配备TI上位机软件用于温度测试-This procedure TI seminars are presented ez430-2500 wireless communication module boards, test procedures. TI is also equipped with useful software for PC Temperature Test
G2553
- msp430g2553官方例程， 很管用！-msp430g2553 Official the routine, msp430g2553 official routine works!
stm32f10x_temple-nb-1401011140
- stm32开发板上通过配置tim2的通道1通道2和tim3的4个通道，产生六路pwm输出波，与l298n模块相连接，控制并实现三个减速电机的变速(STM32 development board, through configuring TIM2 channels, 1 channels, 2 and tim3 4 channels, generates six PWM output waves, and is connected with L298N module, controlling an
WIFI-PWM -子VI - 副本
- 通过labview以及myrio的编程实现电机基本功能以及加减速控制(Achieving the Basic Function of Motor and Acceleration and Deceleration)
SD_CARD_PROTOCOL
- SD卡传输规范，具体内容包括SD卡硬件电路，命令列表，读写时序，校验码生成等内容。-SD card transfer standard, which specifically includes SD card hardware circuit, the list of commands, read and write timing, validation code generation and so on.
sd2
- SD开的协议规范,能够指导大家开发sd卡-this file is about the sd card