资源列表
PID
- Self-tuning PID Controllers ,有需要的朋友可以参考 !-Self-tuning PID Controllers, there is a need of a friend can refer to the reference!
MAX31855
- 热电偶温度检测芯片max31855的资料和自己写的驱动程序。温度检测准确性比较高就是芯片价格有点高。-Thermocouple temperature detection chip max31855 data and writing your own driver. Temperature detection accuracy is higher is the chip price is a little high.
jiaodu
- 关于智能小车上的角度传感器的精确控制系统-Smart small car on the precise angle sensor control system
HY-510Btest
- hy510b 自己买的51 开发板源代码-51 development board hy510b buy their own source code
extkey
- 使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4, 每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port,
HD66773R
- TFT液晶驱动器详解资料，TFT液晶驱动器详解资料-Detailed information on the drive TFT LCD, TFT LCD Detailed information on the drive
IC-Prog
- 多种IC芯片的烧写软件 支持I2CEEPROM 和PIC单片机等-The programming software, multi-IC chip and PIC microcontroller and other support I2CEEPROM
Timer-INt
- stm 32f103定时器中断 代码，在keil环境下调试通过-stm 32f103 timer interrupt code in keil debugging environment through
HCS08EEPROM
- 飞思卡尔HCS08系列单片机内部flash当作eeprom使用的详细例程。-Freescale HCS08 MCU internal flash as detailed eeprom routine use.
stm8s_Lesson5_STM8S_UART
- 介绍了stm8s UART外设的编程方法，内附教程和源码：通过UART数据改变LED的闪烁频率-Introduced the stm8s UART peripheral programming method, with tutorials and source code: through the UART data to change the LED flashing frequency
12864
- msp430f149的ad采集在12864上画波形程序-The ad msp430f149 draw waveform acquisition program 12864
Protel_DXP_2004jiaocheng
- protel dxp的一部经典教程，内容详实，通俗易懂-a classic tutorial of protel dxp