资源列表
Serial-Communication-in-1602-show
- 电脑端发送一串数据，stc单片机接收，并将数据发送回电脑端口，数据送到LCD1602上面显示。已调试成功 !-Computer sends a string of data, stc microcontroller to receive and send data back to the computer side, above the last data sent to the LCD1602 display. Has been successful commissioning
stc89_eeprom
- stc89c52单片机内部自带的eeprom驱动程序，包含擦除，写入，读出三个子函数-MCU internal stc89c52 comes eeprom driver, including erase, write, read three subfunction
ADE7753
- 单相多功能仪表IC--ADE7753能量芯片的接口部分源代码-single-phase multi-function IC instrumentation -- ADE7753 energy chip interface part of the source code
1js
- 一位计数器，按p3.2数码管加1，到9后回0,同时小喇叭响一下报警码管数据p0,数码管控制p2口,按键p3.2口 ，喇叭p3.3-a counter, according to p3.2 plus a digital pipe to the back nine after 0, Also horn ring for what police code of data p0, digital control p2 mouth, keypad p3.2 mouth, the loudspeaker p
TEST44X_dataflash(AT45DB041)
- MSP430单片机DATA-FLASH源程序 经验证可以实现
idw
- A line idw code ,can read and download.
pic_autobaud
- pic单片机的自动波特率检测程序，思路不同于51单片机。-pic microcontroller automatic baud rate detection program, ideas, different from the 51 SCM.
shizhong
- 这是一个基于8051单片机的用c语言写的一个时钟程序，个人原创哦-This is a 8051 based on the use of c language program written in one clock, personal original Oh
2401
- 基于430F169的nr2401的发送程序-Based on the nr2401 send 430F169 procedures
TX-1BDS18B20
- 本文作者采用AT89C2051单片机和温度传感器DS18B20从硬件和软件两方面介绍了一款简易数字温度计的设计过程， 并对硬件原理图和程序流程图作了简洁的描述。数字温度计与传统的温度计相比，具有读数方便，测温范围广，测温准确，其输出温度采用数字显示，主要用于对测温比较准确的场所。-The author of this article using AT89C2051 MCU and temperature sensor DS18B20 from both hardware and sof
hongwai_receiver
- 一个红外接收的程序，对红外遥控的设计具有一定的参考价值-An infrared receiver of the procedures, the design of infrared remote control has a certain reference value for
can4
- can总线收发器MCP2515源程序4，用于can总线收发芯片的调试 -Bus Transceiver MCP2515 can source 4, for the can bus transceiver chip debugging