资源列表
lcd_driver
- 做好的基于arm的lcd 的驱动程序，为毕业设计的一部分-Do a good job based on the arm of the lcd driver for the graduate part of the design
stc232
- 1.通过PC端的串口调试工具，从PC端发出一个十六进制的数， 通过串口传输到单片机，并有单片机通过LED数码管显示其ASII码，而且单片机又将这个数发回PC端，并在PC端显示出来，从而实现单片机与PC机的通讯 2.可以实现对下位机数据实时采集（如温度,程序中设定的是37摄氏度） 3.可以控制流水灯或继电器开关等-1. Through the PC-side debugging tools for serial port, from the PC client sends a hexa
Mifare
- bit TF2 = T2CON^7 sbit EXF2 = T2CON^6 sbit RCLK = T2CON^5 sbit TCLK = T2CON^4 sbit EXEN2 = T2CON^3 sbit TR2 = T2CON^2 sbit C_T2 = T2CON^1 sbit CP_RL2 = T2CON^0 sbit SPEAKER = P1^1 sbit RC500RST = P1^0 sbit LED = P3^4
1226
- 12位AD转换，MAX144芯片，把双路转换结果用串行液晶12864（ST7920)显示出来电压值电流值。-MAX144,12bitA/D，12864LCD show voltage and current，(ST7920 control)
main
- Main.Cpp: C++ ostream + stl + exception demonstration .This file is part of the uVision/ARM development tools. Copyright (c) 2005-2007 Keil Software. All rights reserved.This software may only be used under the terms of a valid, current,end user
cunchu
- 实现将2402与89C52单片机的通信，并将结果用12864检验-To achieve the 2402 and 89C52 microcontroller communication, and the results tested with 12864
CAN-ceshirx
- DsPIC30F4011的CAN总线开发程序，该程序是用于CAN数据的定时发送，标准帧8字节-DsPIC30F4011 CAN bus development program, the program is used for CAN data sending, standard frame is 8 bytes
EM78P153S--2012.3.23-by-li-chunxu
- 完整义隆头文件 EM78P153S 2012.3.23 by李春旭.h -The complete ELAN header files EM78P153S 2012.3.23 by Li Chunxu. H
8279
- 利用单片机以及8279实现键盘值的读入并且显示相应的数值，并且实现shift键的联合使用-Reads and displays the corresponding value of the use of single-chip, and the 8279 value of the keyboard, and the joint use of the shift key
uart1
- 基于AVR MEGA16的串口程序，包含字符串发送及接收程序段-Based AVR MEGA16 serial program, including the string to send and receive blocks
I2C-bus-driver-function
- I2C总线驱动函数,I2C控制总线函数，I2C释放总线函数，I2C数据传输函数-I2C bus driver function
msp430interdemo
- msp430系列单片机,中断demo程序-Controller series microcontroller, interrupted proceedings demo