资源列表
PID_Simulation_Software.rar
- 用VB编写的buck电路仿真软件可以调PID参数，实验证明效果很好。,VB prepared by buck circuit simulation software can be adjusted PID parameters, the experiment proved very good.
emeter-ng
- 智能电表监控程序，包括单相电表和三相电表，采用多个型号的SOC芯片。-Smart meters monitor program
BP25_UCOS
- 基于uCOS的传输中断和挂起实验代码，是运行于STM32的程序。-UCOS-based transmission interrupt and suspend experimental code is running on the STM32 procedures.
MSP430-note
- < MSP430单片机自学笔记>> 一书的光盘资源。项目源代码和实验例程-this is MSP430 MCU books resource with IAR for MSP430
16X64LED_ADs_Sceen
- 16*64电子广告牌，可作为毕设，可以左右上下移动，附带仿真图-16* 64 electronic billboards as a complete set, you can move around up and down, with simulation map
Construction_of_wireless_signal_transmission_syste
- 构建无线人体动态信号传输系统:Construction of wireless signal transmission system of human dynamics-Construction of wireless signal transmission system of human dynamics: Construction of wireless signal transmission system of human dynamics
6.加速度计
- 使用efm32zg开发加速度，adxl345作为加速度的输出芯片(Using efm32zg to develop acceleration, adxl345 as an acceleration output chip)
Mikrocontroller_C8051f34x
- c8051f320 microcontroller
crcn
- 基于Ramos的多信道的仿真代码.主要针对是否使用了多个信道的问题。在tr文件中查看其MAC地址就可以看出一个节点使用了多个信道。-The code of the multi-interface and multi-channel simulation.
Jgs
- 激光加工控制系统 可以读入plt文件，然后仿真，再通过并口 输出x y步进电机的驱动信号及开关光信号 实现激光雕刻
asdf
- 通用射频参数测试系统软件架构设计Universal RF Parametric Test System Software Architecture Design-Universal RF Parametric Test System Software Architecture Design
USB-HID
- PLC1343的USB HID程序，能够直接通过USB下载到芯片内部，能够通过上位机来验证通信。-PLC1343 USB HID application, can directly via USB downloaded to the chip inside, to verify through the upper machine communication.