资源列表
51
- 基于铁电存储器的数据采集与记录系统的具体程序代码-Based on ferroelectric memory of data acquisition and recording system of the specific program code
SCOM
- 使用单片机C语言编的单片机实验板与上位机的串口通信（可接收上位机命令和根据命令给上位机上传上位机需要的数据）程序，可供单片机开发人员参考。-use C language series micro-controller board and PC serial communications (PC can receive orders and orders under the PC to PC to upload the data needed) process for the developmen
atoasci
- 用ASM语言编写的二十进制转换代码.有价值-ASM language with the two Decimal code. Value
db9
- 串口数据采集，用单片机实现，才用查询发送-serial data acquisition, MCU, using only send inquiries
MSP430_Init
- msp430初始化文件 提供主时钟 子时钟 辅助时钟的初始化-Controller initialization file for the main clock-clock support clock initialization
main
- 本例采用89C52, 晶振为11.0592MHZ，关于如何编制音乐代码, 其实十分简单,各位可以看以下代码.频率常数即音乐术语中的音调,而节拍常数即音乐术语中的多少拍 所以拿出谱子, 试探编吧!
STC89C51RC_RD_PLUS
- STC单片机的头文件，可以和8051通用！
4-4keyboard
- 经典的单片机4*4键盘矩阵c语言程序，学习单片机必备.-Singlechip classic 4* 4 keyboard matrix procedures necessary Singlechip study.
AD
- TLC549采集电压然后用数码显示采集的电压-TLC549 collected voltage and then use the digital display of voltage acquisition
keypad_lock
- It the code of Locking your electronic devices using keypad
01~999de-jishiqi
- 01~999的计时器，c语言编写，后面会附上电路原理图，可以让初学者参考一下，结合其他的代码，掌握写法-01 ~ 999 timer, c language write, later accompanied by the circuit schematic diagram, allows beginners to refer to, in combination with other code, master written