资源列表
PHILIPSARM
- 飞利浦系列ARM设计资料，包括祥光的器件封装，软件包，应用，原理图等-Philips ARM series of design information, including Yoshimitsu device package, packages, applications, schematics, etc.
temperature_sensor
- 程序基于IAR软件编写的。通过内部传感器并转化为数字信号，然后通过串口发送到PC，在PC机可以看到采样结果。估计对开发无线传感器网络的相关人士比较重要。 -Procedures prepared based on the IAR software. Through an internal sensor and converted into digital signal, and then sent through the serial port to the PC, in PC-sampli
guosai-fengji
- 2015国赛题目，完美解决方案，值得参考，主控STM32，使用空心杯完成题目，方案简单没适应性强-2015 countries title, perfect solution, it is worth reference, master STM32, use hollow cup complete subject, simple solution not adaptable
CRC16-IBM
- CRC16，16位的循环冗余校验，生成多项式为x16+x15+x2+1，一个完整的校验程序，仅供参考。-CRC16, 16-bit cyclic redundancy check generator polynomial x16+ x15+ x2+1, a complete calibration procedure for reference purposes only.
FIFOidle
- 基于STM32，以软件，利用空闲位实现USARTFIFO-Idle bit implementation USARTFIFO
I2C_L3G4200D_TEST_OK
- STM32与L3G4200D陀螺仪的测试程序，I2C接口。-STM32 and L3G4200D, gyroscope test program, I2C interface.
DAC-----VOLTAGE----
- STM32单片机的DA模块输出可调电压。适合做0~5v可调电压源-STM32 MCU DA module output adjustable voltage. Suitable for 0 ~ 5v adjustable voltage source
RFID_RC522_demo
- 这是一个STM32F103ZET6驱动RC522RFID模块的测试程序，可实现多种功能，优化更新中。-this is a testdemo based on STM32F103ZET6 and RC522RFID model.
RealARM2410datasheet
- 华天正real2410开发板应用手册+实验程序-China Tengen real2410 application development board manual+ test program
MCU_Experiment_Routine
- 单片机入门实验例程，包括LED灯滚动实验，正、逆定时器、计数器、时钟、温度控制等30余个实验的原理、操作过程及源代码-MCU Start test routine, including the LED light rolling experiment, and inverse timer, counter, clock, temperature control more than 30 experiments in the principles of operation and the sour
chengxu
- 基于飞思卡尔单片机的各个模块的程序，对于时钟的设定以及其他的拓展功能-Based on the fly think of Carle MCU AD conversion, the clock settings and other functions
Altium3D库
- 很全的Altium designer ku库，不错，跳入直接用(Very full of the Altium designer Ku library, yes, jump into direct use)