资源列表
simplified-signal-generator
- 从100Hz到30MHZ的简易信号发生器-Simple signal generator from 100Hz to 30MHZ
数字频率计
- 数字频率计，基于stm32的中断捕获模式对输入信号进行计数，计算频率(Interrupt capture count)
MCU_Use
- 单片机原理与应用教程.pdf，为方便阅读，我已经加了目录书签-Principle and Application of Singlechip tutorial. Pdf, for the convenience of reading, I have added a directory of bookmarks
Remote-Control-MCU
- 利用互连网的远程单片机控制，利用IP协议及串口协议，可实现远程操控单片机-Use of the Internet for remote MCU control, using IP protocol and serial protocol, which enables remote control MCU
PWM测试最简版本_OK
- 通过配置stm32的TIM3的通道2，使它能输出PWM波形，然后通过改变占空比寄存器，改变波形。(By configuring the channel 2 of the STM32 TIM3, it can output the PWM waveform, and then change the waveform by changing the duty cycle register.)
STM32F0-for-uCOS_II-template
- 基于STM32F0的UCOS_II模板，创建了一个串口打印任务和两个LED闪烁任务，在ST NUCLEO-F091RC开发板上测试通过- Based STM32F0 of UCOS_II template to create a serial print job tasks and two LED flashes, the test ST NUCLEO-F091RC development board through the
applicationsexammplesofavr
- 一款高性能的单片机avr的各种应用实例，很强大啊，谢谢 -A high-performance single-chip applications avr example, it is strong, ah, thank you
NxpRdLib_PublicRelease
- NXPrfid所有高频通信协议的底层驱动函数，还有一些示例，用VS2005以上版本打开-NXP rfid underlying driver of all high-frequency communication protocol function, there are some examples of open VS2005 version
wifi-And-beidou
- 此程序通过定时接收北斗定位信息，以及实时刷新货物的上车下车，并实时把数据传到上位机-This program can receive Beidou positioning information, and refresh the goods get on and off, and real-time data to the upper computer
2.4G-receive
- STM8 2.4G接收初始化,和把接收到的数据来输出PWM。- STM8 2.4G receive initialization, and the received data to output PWM.
风力摆8.3
- 2015年电赛控制类风力摆程序，适合研究pid(2015 electric race control type wind pendulum program)
temp
- 自己做的51单片机温度监控的上位机程序，VC6.0工程-Do their own 51 single-chip temperature monitoring PC program, VC6.0 project