资源列表
step-motor
- 用单片机控制步进马达的C语言控制源程序代码。-MCU control stepper motor control of the C language source code.
dianzhen
- 用于点阵显示屏的控制板的程序，适合于普通串行传输的LED点阵显示屏-Dot-matrix display
DS18B20
- DS18B20的温度采集程序，可通过调用这些函数实现温度的实时采集。-DS18B20 temperature acquisition program, but by calling these functions to realize the real-time collection of temperature.
CC2530Pchaoshengbo
- cc2530与HC—SR04超声波测距模块实现测距-Unicom cc2530 program between the ultrasonic ranging module
LED
- LED显示程序，显示文字，驱动IC为专用的LED恒流驱动IC。-LED display program to show text, driver IC for the exclusive use of constant current LED driver IC.
drv7279
- 本程序将指定的显示缓冲区送显，并将读取的键值送显。 入口参数：显示缓冲区首地址在SADR中,要显示的位数在CNT中。 出口参数: 无。-This procedure will be sent to the designated display buffer significantly, the key will be sent to a significant reading. Entrance parameters: the first address in the display b
IR
- 红外遥控程序 可以用遥控器控制单片机的 功能 *** 红外遥控器键值表 *** 4c 0e 4d 0d 0f 4f 4e 0c 0b 4b 4a 08 48 12 16 4C 40 48 04 00 02 05 54 4D 0A 1E 0E 1A 1C 14 0F 0C-Infrared remote control program
0703
- mega16 下 波形发生器 基本功能+测频 部分源码-mega16 waveform generator under frequency measurement part of the basic functions+ source code
ir-test
- 单片机 红外 遥控 编码 测试程序 初学者使用-Infrared remote control MCU code using the test program for beginners
24c02
- at24c02与液晶的代码，和编程详细解读-at24c02 and lcd
LCD
- 用LCD显示，在LCD1602上显示应有是程序-LCD display, the show should have procedures in LCD1602
1Sdelay
- 51单片机，1秒钟延时程序。程序很简单，单片机高手路过吧。-51 single-chip, 1 second delay program. The procedure is very simple, single-chip master passing.